User Manual

6
Please refer to the chart below for information about the camera’s indicator light:
3. Connection & Installation
This section provides information about the connection and installation of your camera.
3.1 Connection Guide
The camera initially should be connected via the following method:
• WiFi Connection
• Ethernet Connection
3.2 Installation Guide
To install the camera using the included mounting bracket you will need the following items:
• The 2 included mounting screws.
• The 2 included wall anchors.
• The included mounting bracket.
• A power drill or number 2 Phillips head screwdriver.
• A hammer
• A pen or pencil
To begin the installation process, follow the step by step instructions provided below:
1) Select a surface to mount the camera. Ensure that the installation environment can support at least 3 times
the weight of the camera and near a power outlet.
2) Turn the knob holding the arm and bracket counterclockwise to loosen it and adjust the arm so that you have
more room to work.
3) Place the mounting bracket on the mounting surface and with a pen or pencil mark the designated holes for
your screws.
4) Remove the bracket from the mounting surface and drill the marked holes using a power drill.
5) Insert the included wall anchors into the holes and using a hammer, tap the wall anchors into the holes
making them as flush as possible to the mounting surface.
Indicator Light Status
Device Status
Red Light is blinking quickly.
The device is activating.
Green Light is blinking.
The device is ready to connect or is connecting to the network.
Red light is solid and steady.
The device failed to connect to the network.
Green Light is solid and steady.
The device is connected to the network and is functioning normally.
Red Light is blinking slowly.
The device is upgrading itself.