User Manual

8
3. Place a microSD card into the provided microSD card slot, gold pins down, and press to secure.
Note: To perform a factory reset on the camera, hold the WPS/Reset switch for 30 seconds allowing the device to
reset. The device will reboot and be reset to its original factory settings.
3.4 Basic Wiring Overview
On your device you will notice a pre-attached wire pigtail containing 5 wiring connections. These connections contain
a power adapter connection, an Ethernet connection, audio wires (I/O), and alarm wiring. This device comes equipped
with audio capabilities, the audio wiring is featured in the wire pigtail attached to this device. There are no built-in
speakers or microphones on this device. All audio for this device will be provided using external third-party devices
such as microphones and speakers.
Power
The camera will require a basic 12V DC power adapter. This wire also has an optional
grounding (EARTH) wire for additional grounding of the unit.
Ethernet Port
This connection is used to transmit data from the router to the device via an Ethernet cable.
AUDIO IN
This connection allows for the connection of a single channel, external RCA microphone to be
utilized for this device. This can also be useful when setting up two-way audio for your
system.
AUDIO OUT
This connection allows for the utilization of a single channel, RCA speaker.
ALARM
This connection provides alarm in and alarm out features to an external alarm or security
system. The basic overview of these wires are as follows: 1Yellow: ALARM_IN1, 2Orange
ALARM_OUT1, 3Gray Alarm_GND (Ground)