User Manual

138
Latch: Set a length of time that will delay turning off alarms after the external alarm is cancelled. The
value ranges from 0 seconds to 300 seconds, and the default value is 10 seconds. If you enter 0, there
will be no delay.
Region: The setup button takes the user to the motion detection region setup screen for that specific
channel. On the next page is a screenshot of the motion detection region screen.
When the setup button is clicked, the current channel’s interface comes into a full screen view. The user
can then set up to 4 regions, each with their own region name, sensitivity (1-100), and threshold (1-100).
Each region has a specific color, and the region selector tool is displayed when the mouse is moved to
the top of the screen.
Sensitivity is the amount of change required to increase the motion detected by a percentage. The lower
the sensitivity, the more movement is required to trigger an alarm.
Threshold is the level that the motion detection needs to reach to trigger an alarm.
The lower the threshold, the more likely that motion will trigger an alarm.
To designate a zone, click and drag the mouse over the area desired. When a colored box is displayed
over the live feed, that area is now enabled for motion detection. Clicking the FN button will switch the
mode between armed and disarmed, so that clicking and dragging the mouse can either designate a
motion detection zone or remove any motion detection zone markers.
After the motion detection zone is set, click the enter button to exit the motion detection screen.
Remember to click the save button on the motion detection settings screen, otherwise the motion
detection zones will not go into effect. Clicking the escape button to leave the motion detection zone
and will not save the zone setup.
Record Channel: This checkbox allows the user to enable the system to record video for that channel
when a motion detection alarm is triggered. Delay is also associated with this tab, it is the This field
specifies in seconds how long the delay between alarm activation and recording should be.
PTZ Activation: Allows the user to active PTZ functionality to applicable PTZ devices.
Delay: Allows the user to set a delay in between motion event activation.