Manualshelf

User Manual

ManualsBrandsAmcrest ManualsElectronics4K 8-Channel AI NVR (8-Port PoE) Smart NVR, Facial Recognition, Facial Detection & Vehicle Detection - Supports 8 x 4K IP Cameras, Supports up to 2 x 8TB Hard Drives (Not Included)
12345678910
7
USB 2.0 port
USB 2.0 port. Connect a mouse, USB storage device, etc.
Network port
10M/100Mbps self-adaptive Ethernet port.
HDMI
HDMI Output
High definition audio and video signal output port.
VGA
VGA video
output port
VGA video output port. Outputs analog video signal. This connects
to the monitor to view analog video.
GND
Ground end
Power Port
DC12V, DC48V Depending on model.
MIC IN
Audio input port
Bidirectional talk input port. This is used to receive the analog
audio signal from the device such as a microphone.
MIC Out
Audio output
port
Audio output port. This is used to output the analog audio signal
to devices such as an external RCA speaker.
Bidirectional talk output.
Audio output on 1-window video monitoring.
Audio output on 1-window video playback.
PoE Ports
PoE ports
Built-in switch on certain compatible devices.
For PoE series products, you can use this port to provide power to
a PoE camera.
Hardware Setup
A hard drive allows you to store recordings and events from the NVR, this includes playing back previously
recorded footage and AI events.
Note: This section only applies to NVRs purchased without a hard drive already preinstalled. Most ‘kits’ or
‘bundles will come with a pre-installed hard drive.
The NVR has connections for only 1 hard drive inside the case and the hard drive must be no larger than
8TB (Terabytes).
To install your hard drive, the following is needed:
A medium sized (regular) Phillips-head screwdriver - not included
A hard drive - not included (unless you purchased a ‘kit’ that does have one included)
Four hard drive fastening screws – included
Note: Before installing the hard drive, make sure the NVR is powered off and completely disconnected
from power.