User Manual

103
Below is a description of the features provided in the Face Detection menu.
Enable: This option is used to enable face detection. Use the channel dropdown to select a
channel. Please note, the channel selected must reflect the same channel enabled in the smart
plan menu.
Type: The type menu allows the user to choose if the AI feature will be controlled by the
camera or controlled by the NVR. Please note, AI by Camera will allow the feature to be
controlled by the camera, AI by Device will allow the feature to be controlled by the NVR’s built
in face detection capabilities.
Face ROI: This option is only available if face detection is available on the AI camera. Face ROI
(region of interest) allows the camera to focus on providing the highest quality image for a
selected region only. The remaining part of the image, outside the region of interest, is
recorded at lower quality or not recorded at all. If the camera records are scene with regions of
higher and lower importance, the compression can be focused on the regions of interest only.
Rule: Allows the user to adjust face detection area on the live view monitoring screen.
Period: Allows the user to set a schedule in which face detection will be triggered.
Post Record: Allows the user to delay recording for a specified time after the event ends.
Alarm Out: Allows the user to set general settings for an external alarm.
General Alarm: Used to enable alarm out features.
Alarm Out: Used to enable one or both alarm out channels.
Latch: The Delay (in seconds) before the system begins detecting for the same alarm/event.
Record Control: The channel currently enabled.
Tour: Used to setup a tour for multiple channels. Please note, this is only applicable for PTZ
controlled devices.
PTZ Activation: Allows the user to activate pan, tilt, and zoom options. Please note, this is only
applicable to PTZ controlled devices.
Voice Prompts: Plays an audio file set by the user once an alert is triggered.
More Settings: Access additional settings such as, buzzer, alarm upload, log, send email.
Buzzer: Enable a buzzer to alert each time an alert is triggered.
Alarm Upload: Allows an alarm signal to be uploaded to the network and retain in the
alarm info menu.
Log: Allows an alarm signal to be uploaded to the network and retain in the log menu.
Send Email: This checkbox allows the user to enable the camera to send an email when
an event is triggered. For more information on how to setup email alerts, please visit
amcrest.com/support
To reset to default settings, click the Default button. To refresh the page, click the Refresh
button. To save the settings, click the Apply button.