User Manual

115
Name: The name used on the detection line. The name will be default to
“NumberStat1”, however, it can be modified.
Direction: The direction in which the rule will apply. The detection line can go from left
to right (A to B) or right to left (B to A).
Alarm: Used to enable/disable the OSD overlay and set enter, exit, and stranded numbers units.
OSD Overlay: Use the clear option to reset and clear the enter/exit data in the interface.
Clear: Clears the data in the OSD overlay.
Enter No.: The amount of people it takes to trigger a person entering the set area to be
counted. For efficiency, it is highly recommended to leave this as default (0).
Leave No.: The amount of people it takes to trigger a person exiting the set area to be
counted. For efficiency, it is highly recommended to leave this as default (0).
Stranded No.: The amount of people it takes to generate an alarm who loiter in the set
area. For efficiency, it is highly recommended to leave this as default (0).
Save: Saves the Alarm settings.
Period: Allows the user to set a schedule in which the people counting feature will be used.
Alarm Out: Allows the user to set general settings for an external alarm.
General Alarm: Used to enable alarm out features.
Alarm Out: Used to enable one or both alarm out channels.
Latch: The Delay (in seconds) before the system begins detecting for the same alarm/event.
Alarm Upload: Allows an alarm signal to be uploaded to the network and retain in the alarm info
menu.
Send Email: This checkbox allows the user to enable the camera to send an email when an event is
triggered.
Record Control: The channel currently enabled.
PTZ Activation: Allows the user to activate pan, tilt, and zoom options. Please note, this is only
applicable to PTZ controlled devices.
Post Record: Allows the user to delay recording for a specified time after the event ends.
Tour: Used to setup a tour for multiple channels. Please note, this is only applicable for PTZ
controlled devices.
Buzzer: Enable a buzzer to alert each time an alert is triggered.
Log: Allows an alarm signal to be uploaded to the network and retain in the log menu.
Voice Prompts: Plays an audio file set by the user once an alert is triggered.
To reset to default settings, click the Default button. To refresh the page, click the Refresh
button. To save the settings, click the Apply button.
Setting Up People Counting
People Counting is a great tool to use to keep track and provide insight into the number of people
entering or exiting a certain area. For more information on how to use People Counting refer to
the information below:
1. Open the Smart Plan menu and activate the People Counting Smart Plan. Click Apply.