Manualshelf

User Manual

ManualsBrandsAmcrest ManualsElectronics4K 16CH AI NVR, Smart NVR, Facial Recognition, Facial Detection & Vehicle Detection - Supports 16 x 4K IP Cameras, Supports 2 x 8TB Hard Drives (Not Included) (No PoE Ports Included)
21222324252627282930
25
Please note, the video wall menu will also provide a separate portion that will display the current bit
rate of each channel. The bitrate for each device is measured in Kb/S. For more details on bitrate and its
relation to the NVR, please refer to the section
1
Recording status
3
Direct PoE Connection
2
Motion detection
4
Camera lock
Preview Control Interface
Move the mouse to the top center of the video of the current channel, and the system pops up the
preview control interface. If your mouse stays in this area for more than 6 seconds and preforms no
operation, the control bar automatically hides.
Instant Playback
Click this button to instantly playback any previous motion detection events that were captured by the
camera. Please note, a hard drive must be installed in the device to playback any recorded events or
snapshots.
Digital Zoom
This option allows you to digitally zoom in on a specific area on the live view interface. To use digital
zoom, click the digital zoom button and click an area on the live view screen. Drag the mouse to select a
zone and release. The live view will zoom in on the set area. To exit digital zoom, right click on the live
view screen to return to its original view.
Manual Record
This option allows you to manually record video. Please note, the NVR can only record videos of a single
channel at a time, if multiple channels are enabled, no footage will be retained. To manually record
video, insert a USB flash drive into a USB port on the NVR and click on the manual record button. Click
on the manual record button again to stop recording. The recording will be saved to the USB flash drive.
Manual Snapshot
Like the manual record button, this option allows you to manually snapshots. To manually take a
snapshot, insert a USB flash drive into a USB port on the NVR and click on the manual snapshot button.
The snapshot will be saved to the USB flash drive.
Audio talk
This option allows for bidirectional talk. Please note, an external microphone and speaker will need to be
applied to the audio in and audio out ports on the back of the NVR for this to function. To activate, click
on the audio talk button and use an external RCA microphone and speaker to talk. To disable this function,
click on the audio talk button again.