Manualshelf

User Manual

ManualsBrandsAmcrest ManualsElectronics4K 16CH AI NVR, Smart NVR, Facial Recognition, Facial Detection & Vehicle Detection - Supports 16 x 4K IP Cameras, Supports 2 x 8TB Hard Drives (Not Included) (No PoE Ports Included)
61626364656667686970
63
Enable: This option is used to enable the register function.
No: The number applied to the proxy in the system.
Port: The port number used when setting up the proxy address.
ID: The ID number that is applicable to the proxy address.
To confirm settings, click the Apply button near the bottom right hand corner. Click the Back button to
exit the interface.
Switch
The Switch menu is used to automatically allocate the IP address according to the specified IP segment.
The network camera can automatically register to the NVR. It is for you to set IP address, subnet mask,
gateway etc. of the switch
Note: This function is for PoE products only. Do not connect a physical switch to the PoE ports of the
NVR as it may cause damage to the unit. The Switch function of the NVR is enabled by default. The IP
segment is 10.1.1.1. Usually we recommend using just the default setup method.
Below is a screenshot of the Switch menu: