User Manual

1. Loosen the screws on the

upper cover and side panel.

2. Attach four screws on the

HDD (Do not fully tighten, only

tighten about 3 times).

3. Place the HDD in accordance

with the four holes on the

bottom of the casing.

4. Turn the NVR upside down

and place the screws in firmly.

5. Tighten the HDD screws

firmly to the bottom of the

NVR.

6. Connect the HDD cable and

power cables to the

motherboard.

7. Put the cover back onto the NVR in

accordance with the clip and then

place the upper cover back onto the

device.

8. Secure the screws on the rear and

side panels.

Setting Up the Cables

The following instructions will show you how to set up the cables for the NVR, cameras (PoE and Wi-Fi),

as well as a monitor or TV screen.

To set up the cable connections, there are 5 major steps:

1. Connect a monitor or TV screen to your NVR. The NVR is compatible with any monitor or screen that

uses a VGA or HDMI connection. For purposes of this guide, we will use a VGA connection. Take a VGA