Instructions / Assembly

WARNING
AMEREC Steam Generators are listed by UL or NRTL Laboratory. The steam generators come assembled and
ready for installation. Check that the size and rating of the generator is suitable for your application, refer to
Steam Room Construction and Generator Sizing Guide (AMEREC document 4211-38).
IMPORTANT
An exhaust fan installed outside the steam
room is strongly recommended to remove
excess steam from the bathroom or shower
area.
AMEREC STEAMBATH GENERATORS
(AK,3K and K200i Compatible 9011-XXX Models)
Note: To be used with the K200i,K60,KT60,K30 or R30K
Control.
SAVE THESE INSTRUCTIONS
READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLATION.
POST "WARNING" LABEL OUTSIDE STEAMBATH FOR SAFETY
WARNINGS. REQUIRED POSTING ON DOOR OF STEAM ROOM
OR ADJACENT TO DOOR FOR ALL COMMERCIAL
INSTALLATIONS.
SECTION 1: GENERAL INFORMATION
AK and 3K Series Installation and Service
Instructions
(K200i Compatible 9011-XXX Models)
Electrical grounding is required on
all AMEREC Steam bath Generators.
All electrical supplies should be
disconnected when servicing
generator.
All wiring must be installed by a
licensed electrical contractor in
accordance with local and national
codes.
All plumbing must be installed by a
licensed plumber in accordance with
all applicable local and national
codes.
AK series generators are for indoor
use only.
AK series generators are not for
space heating purposes.
Be certain that steam bath
enclosures are properly sealed to
avoid water damage from escaping
steam. It is recommended that 100%
silicone caulk be used to seal all
pipes and fittings. Steam must be
prevented from escaping into the
wall cavity.
Never shut off the water to a steam
generator that is in use.
Electric Shock Hazard - High voltage
exists within this equipment. There
are no user serviceable parts in this
equipment.
K200i
OR
K60/KT60
OR
K30
OR
R30K
Possible Controls
4211-171 06-25-10
REDUCE THE RISK OF
1. Exit immediately if uncomfortable, dizzy or sleepy. Staying too long in
a heated area is capable of causing overheating.
REDUCE THE RISK OF
Use care when entering or exiting the steam room, floor may be slippery.
NOTE:
For additional safety instructions, see owner’s manual.
CAUTION!
Do not contact steam head. Stay at least 12" away
from hot steam escaping from the steam outlet.
OVERHEATING AND SCALDING
2. Supervise children at all times.
3. Check with a doctor before use if pregnant, diabetic, in poor health or
under medical care.
4. Breathing heated air in conjunction with consumption of alcohol, drugs
or medication is capable of causing unconsciousness.
SLIPPING AND FALL INJURY
WARNING
AK GENERATOR
STEAM

Summary of content (19 pages)