Specification

CONTROL ROUGH-IN INSTRUCTIONS

4211-137 page 1 of 2 04/05/10

Mount the rough-in plate flush to the stud’s surface,

either directly to a stud

to a double-switch box

Throughout the following steps, make sure the control cable is kept accessible and protected from damage.

It will be needed later to connect the control.

Cut a 2” diameter hole in the wall board or tiles to match the rough-in

plate and foam. Leave the foam in place while finishing the wall and tile

or finish the wall surface over the rough in plate and up to the rough-in

foam.

then remove the rough-in foam

and throw it away.

PAGE 1
CONTROL ROUGH-IN INSTRUCTIONS Mount the rough-in plate flush to the stud’s surface, either directly to a stud or to a double-switch box Throughout the following steps, make sure the control cable is kept accessible and protected from damage. It will be needed later to connect the control. Cut a 2” diameter hole in the wall board or tiles to match the rough-in plate and foam.
PAGE 2
CONTROL ROUGH-IN INSTRUCTIONS Run a bead of silicone around the back of the control then use the 2 screws provided to add the retaining bracket to the back of the control. Note: you may need to rap the screws lightly to break through the switch housing’s screw hole moisture barriers. Run the cable end through the bracket and plug it into the control Push the bracket through the hole and push the control into the wall.