User/Installation Manual ADVANTAGE DKLP MODEL 19-100(i) “Your Partner in Access Control” www.americanaccess.
AAS 2Year Limited Warranty What item(s) this warranty applies to: American Access Systems “DKLP 19-XXX series” access controls. What is covered: Any defect in materials or workmanship. For how long: Two years from date of purchase. What we will do: If your AAS product is defective and returned within 2 years of the date of purchase, we will repair it or, at our option, replace it at no charge to you. If we repair your AAS product, we may use new or reconditioned parts.
PARTS CHECKLIST Enclosed with this box you should have the following items.
STEP 1-MOUNTING THE UNIT Page 3 tells you what tools and instruments you will need to install your unit and presents a parts check list. Make sure to have all the tools listed. Upon opening the box, check off the items enclosed with the unit. If any items are missing from your unit, contact American Access Systems immediately. Mounting the unit to your own pedestal Your unit comes with a square mounting flange found in the bottom of the box along with four carriage bolts and four hex nuts.
HOOKUP STEPS (A). Your DKLP control unit operates on 6 to 14 volts DC. Measure the voltage from the power source to make sure it falls within these tolerances. Locate the Red and Black wire on the ACU HARNESS and with the power off connect Red to positive (+) and Black to negative (-). NOTE: If you are using the optional AAS-12vdc transformer, cut the end connector from the transformer cable and discard. Using appropriate wire nuts, connect black to black and black/white to red. (B).
SUB-MODES “1” Sub-Mode 1 (Enter New Access Codes) To enter new access codes enter the MASTER CODE, followed by 1, then enter each new ACCESS CODE you wish to program into the unit. (MASTER CODE) + 1 + (ACCESS CODE) + (ACCESS CODE) etc... (# to exit) Should you make an entry error, simply press the * key and re-enter the correct data. You may continue entering access codes until the memory is full or the # is pressed. You may select any 4 digit access code that is not already in use by the system.
DKLP CIRCUIT BOARD DIAGRAM PROGRAM/RESET BUTTON POWER/CONTROL HARNESS (JP1) RELAY Page 7 American Access Systems / Security Brands, Inc.
MASTER CODE ____________ Page 8 American Access Systems / Security Brands, Inc.
Customer Service and Tech Support Customer Service: 303-799-9757 Customer service is available free of charge. Hours are 8:00 a.m. to 4:30 p.m. MST. If you call, please have your Model and Serial Number to help our Technicians assist you. E-Mail: customerservice@securitybrandsinc.com Technical Support: 303-799-9757 Technical support is available free of charge. Hours are 8:00 a.m. to 4:30 p.m. MST. If you call, please have your Model and Serial Number to help our Technicians assist you.
Notes Page 10 American Access Systems / Security Brands, Inc.
Notes Page 11 American Access Systems / Security Brands, Inc.
“Your partner in access control” www.securitybrandsinc.