C -11 Powered Subwoofer Owner's Information
C-11 Powered Subwoofer Information Important Instructions 1. Read your owner's manual carefully before using the product. Retain this manual for future reference. 2. The subwoofer should be placed at a ventilated, dry and cool location, away from any heat sources such as radiators or amplifiers. Do not obstruct the amplifier in the C-11 from ventilation. It is necessary that air can flow around the finned heat sink on the rear panel of the amplifier. 3.
proprietary 10” drivers, the C-11 produces clean, powerful and controlled bass. Three large rear-firing vents ensure ventilation of both driver and amplifier for cool running at high power. The vent's large bore and “gas flowed” cross-section reduces air turbulence that causes audible distortion. Functions and Connections Please refer to Fig. 3 (Front control panel) and Fig.
Power switch on/off Upper position: Power on Lower position: Power off Middle position: Auto on At this position the subwoofer amplifier is in a stand by mode, awaiting an input signal. When there is no signal, the amplifier is shut down. As soon as the signal appears, the amplifier switches on. If signal is absent, the amplifier will shut down automatically after a pre-determined period of time.
pressure wave. You can use this position if you are unable to get a good integration between the subwoofer and main speakers. Equalizer on/off At “off” position, the amplifier will function normally without the effect of the 5-band equalizer.
Connection Please see diagrams below for different method of connecting the subwoofer to your main amplifier/receiver. It may be possible to use alternative connecting methods. Please refer to the owner's manual of your amplifier/receiver or seek professional advice from your retailer or installer. CAUTION! Before switching power on, please make sure all connections are made properly, i.e., positive to positive, negative to negative.
Setting up EQ or the Room Play some familiar pieces of music that have prominent bass lines. Start with the EQ switched out and then adjust the EQ filters one by one switching the EQ in and out. It is better to start with the EQ cutting the frequencies and not boosting them. Remember that a 10 dB boost is adding ten times the power at that frequency so it would be easy to overload the system at high power levels with the EQ sliders set at maximum.
Service and Warranty The C-11 Subwoofers have a warranty period of 1 year, starting from the date of purchase. This warranty is provided to the original owner who purchased the product from an authorized dealer. This warranty covers defect in materials or workmanship that occurs in normal use only, and excludes damage that results from abuse, mis-use, accidents, shipping, or repairs or modifications by anyone other than authorized representatives. The warranty is void if serial number has been removed.
VOLUME MIN MAX 25Hz FREQUENCY 30 40Hz Hz 160 60Hz 80Hz PHASE 0¡ã 180¡ã 100Hz POWER OFF EQ +10dB +10dB AUTO 0dB 0dB ON -10dB -10dB OFF ON C-11 Product C-11 Specifications Amplifier type Solid state Class A/B Power 160 watts continuous into 4 Ohm Woofer Proprietary 10” diaphragm Aluminum Cone / 60 Az magnet / 2” voice coil Frequency response 30 Hz to 160 Hz +/- 3 dB Electronic crossover Continuously variable from 30 Hz to 160 Hz 24dB/octave Phase control Variable 0 - 180 5
www.aadsound.