Specifications

Q-D1™ CONTROLS AND FEATURES

1. MASTER VOLUME CONTROL - This rotary knob is used to control the master output level (volume).

To avoid distorted output try to maintain an average output signal level +4 dB. Be sure this volume

control is always set to zero before turning the unit on.

2. MIC LEVEL - This rotary knob is used to control the microphone volume output level. Turning the

knob in a clockwise direction will increase volume output.

3. CHANNEL BASS CONTROL - This knob is used to adjust the low frequency levels of a channel

allowing for a maximum bass gain of 12dB or maximum signal decrease of -26dB. Turning the knob

in a counter-clockwise direction will decrease the amount of bass applied to a channel signal, turning

the knob in a clockwise direction will increase the amount of bass applied to a channel signal.

4. CUE MIXING CONTROLLER - This switch selects the channel for monitoring. The monitor signal

comes from the Prefader. This means it will not be affected by the channel faders. You can monitor

each channel individually. Connect your headphones to the HEADPHONES jack. Flip the CUE MIXING

CONTROL switch to channel you wish to monitor. If the CUE MIXING CONTROL is set to the center

position, you can monitor both the channels at once.

5. “Q” START ON/OFF

- This function works in conjunction with a compatible American Audio® "Q"

Top Panel

7 6