Power Pro 300 Source Switching Amplifier OWNER’S MANUAL
WARNING TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE THIS PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. TO PREVENT ELECTRICAL SHOCK, MATCH WIDE BLADE PLUG TO WIDE SLOT, FULLY INSERT.
Power Pro 300 Source Switching Amplifier Congratulations on your purchase of Mclelland Using the Controls/ Front Panel Power Power Pro 300. Please take a few moments to read this entire manual, and be sure to reta in this document for futu re refe rence. Please read and observe all safety instru ction s detailed on page two (2). ! The front panel switch will manually switch the Power Pro 300 on or off. A blue LED behind the faceplate lens indicates its power status.
Master Level Controls Each channel is able to control its volume independently relative to the other channel. At the bottom left of the rear panel, there are 2 screwdriver adjustment knobs which correspond to the volume level of the channel identifie d by a channel designator below it. As an example, if the “Line 1 Input” source was a CD Changer, The delay could be adjusted to prevent switch ing back to the “ Line 2 Input ” source while the changer moves from one disc to another.
This limited warranty applies only to purchases from authorized MA Electronics retailers. This limited warranty is extended only to the original purchaser. Consumers are required to provide a copy of the original sales invoice from an authorized MA dealer when making a claim against this limited warranty. This limited warranty only covers failures due to defects in materials or workmanship that occur during normal use.
Stereo Setup The distrib uted audio is then passed on to be used by addition al zones or sub zones in the distrib uted system via the Line 2 outputs. The Audio output of a local source, such as MP3 Player, CD, televisio n, computer, etc. is connected to the Power Pro 300 via the televisio n, computer, etc. Is connected to the Power Pro 300 via the Line 1 inputs, and whenever the local source is active its signal will take priority over the distrib uted audio signal present at Line 2.