User Guide

11.Loop play
You can loop between two points continuously
Press IN REAL TIME CUE Button for starting point
Set end point by pressing OUT/ EXIT Button, CD will begin looping until OUT/ EXIT Button is pressed
again.
Press Reloop to again enter the loop.
Note: this is not a seamless function.
12. Time Display
During normal play, each time you press TIME button, the display changes to give you the following
information. (Fig.14)
A = Elapsed playing time.
B = Remaining time in a selection. If the current selection number is over 34, ‘...................” is displayed.
C = Total remaining time of the disc.
13. Repeat playback
1) Press REPEAT button, the REPEAT 1 indicator lights, the player repeats the one track selected.
2) Press REPEAT button again, the REPEAT ALL indicator lights. The player will then repeat all tracks
on disc.
3) Press REPEAT button again, the repeat function is cancelled.
14. Pitch Bending
• The speed increases or decreases respectively while the PITCH BEND+ or PITCH BEND- button is
pressed. The extent to which the speed changes is proportionate to the amount of time the button is
pressed. For example, if the PITCH BEND+ button is held in continuously, the speed increases
continuously.
• The pitch changes within a range of +/- 16%.
• The jog wheel will temporarily bend the pitch of the music if the song is already playing by rotating the
wheel clockwise to speed up or counterclockwise to slow down. The speed that you rotate the JOG
Wheel determines the percent of pitch bend.
1. Find the BPM of the song playing by pressing BPM button. Then tap COUNTER button firmly to the beat of
the music until BPM is displayed on the LCD.
2. Repeat step 1 for the song you want to mix in. You can listen in by cueing it in your headphones using your
mixer or follow the BEAT LED on the CD.
3. Engage Pitch by pressing PITCH on the side you want to use ,make sure Readout is in BPM by pressing
BPM Button until BPM is lit on LCD. Adjust pitch until same BPM as original song is reached.
15. Program Play
Press PROG. Button to make the unit enter the program mode and stop condition.
The program indicator lights. Select Track using NUMBER button press PROG. again.
Repeat this up to 30 times.
Press play Button to begin playing programmed tracks.
To cancel Program press and hold PROG. Button more than 2 sec.
MATCHING THE BEATS PER MINUTE (BPM)
American DJ® AUDIO • DCD-PRO300™ INSTRUCTIONS MANUAL • PAGE 10