User`s guide

ProControl Guide142
In SENDS mode
■ The SELECT/ASSIGN switch toggles between pre- or post-
fader routing for the associated send.
ASSIGN/ENABLE
The ASSIGN/ENABLE switches are located immediately to
the left of each LED display. For each insert row, this switch
will:
◆ Initiate and complete the assignment of a Plug-In or Send
to an unused Insert, or the destination of the current send.
– or –
◆ Toggles automation enabling on/off. This shortcut is
equivalent to choosing a Plug-In parameter for automation
in the Pro Tools Plug-In automation dialog.
Instructions for these and all Plug-In/Send features begin
with “Assigning Plug-Ins” on page 146.
BYPASS|IN/OUT/Ø/MUTE Switch
The BYPASS|IN/OUT/Ø/MUTE switches perform three func-
tions depending on the current DSP EDIT/ASSIGN mode:
In INSERTS mode
◆ Allows BYPASS of Plug-In inserts. (Hardware inserts can
not be bypassed.)
In PARAMs (Plug- In Edit) mode
◆ The function of any switch in the row is determined by
the Plug-In itself. Any Plug-In that has switched parameters
where there are two states to the control (such as on/off,
in/out) will show up on this row of switches. Examples of
switch functionality in this mode include filter band In/Out
(as found in the Focusrite d2 or Digidesign EQs) and Plug-In
Polarity (phase inverted or normal).
In SENDS mode
• Mutes the associated send.
COUNTER MODE
1
2
3
4
ASSIGNSELECT
IN/OUT/ØAUTO ENABLE
BYPASS
INSERTS
PARAM
INFO
SENDS
Bus 1-2 
No Send
No Send
No Send
ASSIGN/ENABLE
COUNTER MODE
1
2
3
4
ASSIGNSELECT
IN/OUT/ØAUTO ENABLE
BYPASS
INSERTS
PARAM
INFO
SENDS
EQ
Comp
no ins
no ins
BYPASS/In, Out/Ø/MUTE