User`s guide

ProControl Guide180

To record dynamic automation of a Plug-In:

1 Make sure that Plug-In automation is enabled in the AU-

TOMATION/ENABLE switch section.

2 Set the appropriate channel to the desired automation

mode (Write, Touch, Latch, Trim, etc.)

3 Press a channel INS/SEND switch. This displays the cur-

rent Inserts/Sends for the channel in the DSP EDIT/ASSIGN

displays.

4 Select the Plug-In you wish to automate by pressing the

corresponding SELECT/AUTO switch. To access another

page, press any lit CHANNEL MATRIX switch (1-32). To arm

or disarm the MASTER BYPASS function for automation,

press OPT(ALT)ALL > MASTER BYPASS.

5 With the desired automation parameter displayed in the

DSP EDIT/ASSIGN displays, press the corresponding AS-

SIGN/ENABLE switch. The display temporarily displays

AUTO ON and the ASSIGN/ENABLE switch illuminates. If

the channel is already armed for automation recording, the

SELECT/AUTO switch will begin to ﬂash.

6 Press PLAY. Automation recording begins.

7 Rotate the parameter encoder in the DSP EDIT/ASSIGN

section. The SELECT/AUTO switch indicates that the en-

coder has been touched and is recording automation. Fol-

lowing all Pro Tools settings for touch time-out and

thinning, automation will be recorded to the Plug-In auto-

mation playlist.

8 You can punch-out of automation recording at any time

by pressing the appropriate SELECT/AUTO switch. For more

information on punching out of automation recording, re-

fer to the next section.