User`s guide

ProControl Guide192
Reset and UNDO
Changes to UTILITY parameters are applied
as you make them. In other words, you
cannot ESCAPE out of UTILITY mode with-
out saving any changes you have made —
they are saved as soon as a new parameter
is selected. To reset a UTILITY parameter
you must manually access and reset the op-
tion.
Display of UTILITY status
UTILITY mode choices and settings are dis-
played in the DSP EDIT/ASSIGN and Chan-
nel scribble strip displays.
When editing parameter choices on the
UTILITY pages, menu choices which are
currently enabled, or active, are indicated
by a lit switch LED. Other available choices
are shown with a flashing ASSIGN/ENABLE
switch LED.
To select/edit a UTILITY parameter:
■ Press the flashing ASSIGN/ENABLE
switch in the DSP EDIT/ASSIGN section as-
sociated with the parameter you want to
edit. If an ASSIGN/ENABLE switch is lit
solid, then the default choice is enabled.
The above basic steps are used to edit and
select all UTILITY modes and parameters
on a Main Unit or Fader Pack.
Example of UTILITY Selection
Throughout the remainder of this Appen-
dix, UTILITY instructions are listed in ab-
breviated form. For example:
To access the Vegas Test Mode UTILITY
page:
■ In UTILITY mode, choose TEST > LED >
VEGAS.
The above instructs you to:
1 Press UTILITY.
2 Choose TEST from the UTILITY menu,
then
3 Choose LED from the TEST menu that
appears, then
4 Choose VEGAS from the LED menu.
For operations which take place purely
within the UTILITY menus, the short-form
instructions will appear. Wherever alter-
nate methods of invoking a UTILITY-level
parameter is available, its instructions are
included. Refer to the index of this guide to
locate specific settings.