User`s guide

ProControl Guide50
Stereo mode
Pressing MONO will mono-sum signals to the
MAIN output as well as the (front-panel) headphone out-
put.
Surround mode Only the STEREO MIX outs are affected by
MONO. To confidence mix surround stems in Mono, sim-
ply press the MONO switch and then select each stem, one
pair at a time with the STEREO MIX (front left/right), SRC 1
(surround left/right) and SRC 2 (center, sub) switches.
Control Room DIM Switch
The DIM switch (yellow LED) inserts a 15 dB reduction in
level to the control room outputs. Depending on the cho-
sen monitoring mode, most or all of the outputs will be af-
fected by DIM as follows:
Stereo mode DIM affects MAIN (1-6) and ALT (3-4) outputs
only.
Surround mode DIM affects all outputs at all times (MAIN,
ALT, AUX). All six outputs of a surround matrix are affected.
The DIM switch does not affect the AUX (5-6) output (use
the AUX (5-6) rotary knob to lower this output level). It also
does not affect the front-panel headphone feed or
Slate/Dub feed. Press the DIM switch again to return to nor-
mal monitoring levels. The DIM switch LED extinguishes.
Control Room ALT Switch
In stereo mode, when enabled, the ALT switch (green LED)
routes the control room monitor mix to ALT Monitor Out.
This will usually be connected to an alternate set of moni-
toring speakers. Pressing the ALT switch disables the feed to
Main Monitor Out. In surround mode, this switch is inac-
tive. ALT state is remembered when switching between sur-
round and stereo monitor modes, and when powered
down.
CONTROL ROOM
AUX (5-6)
TALKBACK
MIX TO
AUX
ALT
MUTE
MONO
HEADPHONE
DIM
MAIN (1-6)
ALT (3-4)
TRIM 5
TRIM 6
STEREO MIX
SRC 1 (3-4)
SRC 2 (5-6)
SRC 3