User manual

©American Audio® - www.americanaudio.eu Encore2000™ User Manual Page 16
7. SET-UP PRECAUTIONS
Please be sure to make any connections before plugging the device in to an electrical outlet.
All fader and volume controls should be set to zero or minimum position, before the device
is switched on.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation),
do not switch on the device immediately. The arising condensation of water might damage
your device. Leave the device switched off until it has reached room temperature.
7.1 OPERATING DETERMINATIONS
When installing this device, please make sure that it is not exposed to extreme heat,
moisture or dust!
Do not operate the mixer in extremely hot (more than 40°C / 104°F) or extremely cold
(less than 5°C / 40°F) surroundings.
Keep the unit out of direct sunlight and away from heaters.
Operate the device only after becoming familiar with its functions. Do not permit
operation by persons not qualified for operating the unit. Most damages are the result
of unprofessional operation!