User manual

©American Audio® - www.americanaudio.eu Encore2000™ User Manual Page 46
15. RELAY PLAYBACK
This feature is a kind of “auto pilot”. When you are using the Encore2000™ system, you can
have one player begin playback when the other ends. You can relay single tracks, the entire
disc, or a combination of the two. This feature is sometimes referred to as Flip-Flop™
playback.
To relay single tracks, proceed as follows:
By default the two players are set to playback in single mode, Single (61) will be
indicated in the LCD (20).
Set the mixer's crossfader to the center position, and press the Relay Button (27).
Load your two players with audio discs.
After they have both cued, press the Play/Pause Button (13) on one player to begin
playback.
After the first player’s single track has ended the second player’s track will immediately
begin playback.
Relay (FLIP-FLOP™) will continue until you stop it or power is interrupted.
To relay entire CDs, proceed as follows:
Be sure your players are both in continuous play mode, make sure Single Mode (61)
does not appear in the LCDs (20) of both players. Follow all directions for single track
relay above. When one player’s disc ends the other player will immediately begin
playback.
Note: You may combine relay single and continuously playback modes by selecting either
single or continuous playback on your units. In Relay Mode the decks are set single play
mode by default.
Note: Make sure that neither deck has Repeat Mode activated during Relay Mode. Repeat
Mode has priority over Relay Mode.