Owners Reference AV-3000 and AV-5000 Power Centers 4826 Sterling Drive, Boulder CO 80301 PH: 720.406.8946 service@psaudio.com www.psaudio.com ©2009 PS Audio International Inc. All rights reserved.
Introduction AV-3000 and AV-5000 Power Centers Important Safety Information 1) Read these instructions. 2) Keep these instructions. 3) Heed all warnings. 4) Follow all instructions. 5) Do not use this apparatus near water. 6) Clean only with dry cloth. 7) Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. 8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
Table of Contents AV-3000 and AV-5000 Power Centers Table of Contents 1. Introduction 1.1 Device Description 1.2 Device Features 2. Installation and Operating Instructions 2.1 Unpacking and Inspection 2.2 Overview 2.3 Installation 2.4 Self Test and Power Up 2.5 IP Status 2.6 Configuration and Control 2.6.1 Internal Website Control 2.6.1.1 Control Panel – System Status 2.6.1.2 Control Panel – Configuration 2.6.1.2.1 Unit Name 2.6.1.2.2 Front Panel Lock 2.6.1.2.3 Front Panel Dim 2.6.1.2.4 Zone Name 2.6.1.2.
Installation and Operating Instructions AV-3000 and AV-5000 Power Centers 1. Introduction 1.3 Device Description The AV Power Centers are a revolutionary power conditioner, which not only offers world class protection and noise reduction, but also offers unparallel flexibility and control. 1.4 Device Features • Advanced Control Ethernet and RS-232 ports provide two way communication to the Power Centers. These ports enable unparalleled control, monitoring, and management of connected devices.
Installation and Operating Instructions AV-3000 and AV-5000 Power Centers • Auto Reboot When enabled the Auto Reboot feature will reboot your modem, router, and/or any other device critical for internet access should the PowerPlay go more than 10 minutes without an internet connection. This feature ensures your Power Play is always available online. 2. Installation and Operating Instructions 2.1 Unpacking and Inspection Upon receipt inspect the packaging for damage.
Installation and Operating Instructions AV-3000 and AV-5000 Power Centers 2.2 Overview Device Overview AV-5000 Front Panel AV-5000 Rear Panel 4826 Sterling Drive, Boulder CO 80301 PH: 720.406.8946 service@psaudio.com www.psaudio.com ©2009 PS Audio International Inc. All rights reserved.
Installation and Operating Instructions AV-3000 and AV-5000 Power Centers AV-3000 Front Panel AV-3000 Rear Panel 4826 Sterling Drive, Boulder CO 80301 PH: 720.406.8946 service@psaudio.com www.psaudio.com ©2009 PS Audio International Inc. All rights reserved.
Installation and Operating Instructions AV-3000 and AV-5000 Power Centers 2.3 Installation Placement The AV Power Center must be installed in a protected environment away from heat emitting devices. Do not install this unit where it may be exposed to excessive moisture. Rack Mounting Rack mounting hardware is provided for use with your PS AV Power Center. Please us only the included hardware for rack mounting the device.
Installation and Operating Instructions AV-3000 and AV-5000 Power Centers NOTE – Devices with large inrush currents, such as amplifiers, should only be placed on the parallel filtering outlets. Although other outlets will power such devices, large inrush currents may damage the relays which control the on and off settings of the outlet.
Installation and Operating Instructions AV-3000 and AV-5000 Power Centers 2.6 Configuration and Control There are 2 methods for configuring and controlling the PS AV Power Center. The preferred and most powerful method of control is via the AV Power Center’s internal website. The other method of configuration is accomplished via the front panel. 2.6.
Installation and Operating Instructions AV-3000 and AV-5000 Power Centers Master Power – To alter the power state of your PS AV Power Center click on the System Power bar. When the Master Power is on the bar will be blue, and when off the bar will be red. Master Power On Master Power Off Identify and Control Outlets – Outlet numbers and custom labels are displayed when the pointer hovers on top of the smaller boxes representing the outlets banks. Click on any outlet bank to toggle the power.
Installation and Operating Instructions AV-3000 and AV-5000 Power Centers 2.6.1.2 Control Panel – Configuration The Configuration page allows you to control some of the more advanced features of PS AV Power Center such as device name, front panel lock, display outlet naming, Switch Mode and UPS Priority 2.6.1.2.1 Unit Name You may enter a description of your PS AV Power Center to help you remember the location within your home, such as “Theater Rack” 2.6.1.2.
Installation and Operating Instructions AV-3000 and AV-5000 Power Centers 2.6.1.2.3 Display Level Change the brightness of the PS Audio logo power button and display Bright Default - full brightness Dim Dims the display Off Defeats the display. Note: When the Display Level is set to Dim of Off touching the capacitive display (AV-5000 only) or buttons will illuminate the display to Bright for 10 seconds and then return to the selected setting 2.6.1.2.
Installation and Operating Instructions AV-3000 and AV-5000 Power Centers 2.6.1.2.
Installation and Operating Instructions AV-3000 and AV-5000 Power Centers 2.6.1.2.6 UPS Priority When PS AV Power Center is connected to a PS Audio PowerPack battery backup you may control how each outlet shuts down in a battery backup situation. Using the drop box you may select one of the following options: None – No battery backup is provided to these outlets in order to quickly reduce the load and extend battery life. Use this setting for amps, subwoofers and other large draw devices.
Installation and Operating Instructions AV-3000 and AV-5000 Power Centers 2.6.1.3 Control Panel – Infrared Codes The Infrared Codes page allows you to setup your PS AV Power Center to issue IR commands to any connected device as if you were standing there with the original remote for the device. In order for this feature to work you must integrate your PS AV Power Center with an IR distribution system. To add a new IR command click on Add New Code 1. Enter a name for the command you wish to setup. 2.
Installation and Operating Instructions AV-3000 and AV-5000 Power Centers 2.6.1.4 Control Panel – Network The Network page allows you to modify the network settings of your PS AV Power Center unit. Please exercise extreme caution when modifying any settings as the incorrect settings will result in loss of network connectivity. Host Name – The Host Name can be used to access your PowerPlay by typing a name into your browser rather than the local IP address.
Installation and Operating Instructions AV-3000 and AV-5000 Power Centers NOTE: Any changes in the network setting will require a reboot of the Power Center. IMPORTANT: It is highly recommended that the Direct Ethernet Connection be disabled after setup. Enabling the DCHP server can result in IP conflicts if other DCHP servers reside on the network. 2.6.2 Front Panel Configuration Front Panel based setup offers very limited configuration and control of your PS AV Power Center.
Installation and Operating Instructions AV-3000 and AV-5000 Power Centers 1. Select the outlet you wish to modify by touching the corresponding outlet on the front panel. Once selected the outlet will begin to flash. 2. Touch the outlet again while the indicator is flashing to toggle between power on and power off. Note: There is no delay or IR settings associated with direct panel control. Changes made to the power settings are immediate. 3.
Installation and Operating Instructions AV-3000 and AV-5000 Power Centers 2.6.2.1.6 Outlet Labeling 1. Select the outlet you wish to modify by touching the corresponding outlet on the front panel. Once selected the outlet will begin to flash. 2. Press SELECT and in the LCD window you will see the switch mode begin to flash. Press SELECT again, you will see the Outlet Label begin to flash. We are now ready to modify the Outlet Label. 3.
Installation and Operating Instructions AV-3000 and AV-5000 Power Centers 2.6.2.2 AV-3000 From the front panel of the AV-3000 you may alter the main system power, check device status, and alter the power state of any zone. 2.6.2.2.1 PS AV Power Center Master Power You may toggle the Master Power setting of your PS AV Power Center by pressing the blue PS Audio logo button located in the center of the front panel.
Warranty AV-3000 and AV-5000 Power Centers Terms and Conditions PS Audio provides a 90 day manufacturer’s warranty on all new PS Audio components. PS Audio offers an optional extended 3 year warranty in exchange for completing a valid product registration. This optional extended warranty is available for new products, when that product is registered through PS Audio with the serial number and name of the authorized dealer or distributor that sold it to you.
Warranty AV-3000 and AV-5000 Power Centers Transfer of Warranty This Warranty is for the benefit of the original purchaser of the covered product and may be transfered to a subsequent purchaser of the product. 1. Extended warranty policies: By registering this product, via mail or internet, within 90 days of purchase, the warranty period will be extended to 3‐years from the date of purchase. 2.
Warranty AV-3000 and AV-5000 Power Centers Outside the US PS Audio has authorized distribution in many countries of the world. In each country, the authorized importing retailer or distributor has accepted the responsibility for warranty of products sold by that retailer or distributor. Warranty service should normally be obtained from the importing retailer or distributor from whom you purchased your product.
Service AV-3000 and AV-5000 Power Centers If you require service in North America In the unlikely event there is a problem with your PS Audio component, please contact your dealer, distributor, or the PS Audio corporate research center to discuss the problem before you return the component to our facilities for repair.
Service AV-3000 and AV-5000 Power Centers To purchase additional packaging, please contact your authorized PS Audio dealer, distributor, or the PS Audio Service Department for assistance. If you are outside the US If you are outside the United States and require service you must contact your country’s dealer or distributor for instructions. PS Audio warranties its products (see warranty section) worldwide.
Specifications AV-3000 and AV-5000 Power Centers 5.
AV-3000 and AV-5000 Power Centers 4826 Sterling Drive, Boulder CO 80301 PH: 720.406.8946 service@psaudio.com www.psaudio.com ©2009 PS Audio International Inc. All rights reserved.