Operating instructions

Installation and Operating Instructions
AV-3000 and AV-5000 Power Centers
4826 Sterling Drive, Boulder CO 80301 15-052-21-1 Rev B
PH: 720.406.8946 [e-mail]
www.psaudio.com
©2009 PS Audio International Inc. All rights reserved.
NOTE: Any changes in the network setting will require a reboot of the Power
Center.
IMPORTANT: It is highly recommended that the Direct Ethernet Connection be
disabled after setup. Enabling the DCHP server can result in IP conflicts if other
DCHP servers reside on the network.
2.6.2 Front Panel Configuration
Front Panel based setup offers very limited configuration and control of your PS AV Power
Center. It is highly recommended that this option only be used when you are unable to setup PS
AV Power Center via the network based through the internal web server, or to make small simple
changes while in front of the unit.
2.6.2.1 AV-5000
From the front panel of the AV-5000 you may change the names of each outlet and the
switch mode for the outlet.
2.6.2.1.1 PS AV Power Center Master Power
You may toggle the Master Power setting of your PS AV Power Center by
pressing the blue PS Audio logo button located in the center of the front panel.
The Master Power setting will only affect the outlets you have set to Switched,
Delay and/ or Programmed. All other outlets will remain on.
The IP Indicator will remain illuminated when the power is off.
2.6.3.1.2 IP and Device Status
You may look up the IP Status by touching the IP indicator. The status of PS AV
Power Center will advance with each touch as follows:
1. Unit Name
2. Local IP Address
3. Hostname
4. Unit ID Number
5. MAC Address
6. Firmware Version
2.6.2.1.3 Controlling Outlets
Each outlet has a power indicator on the front panel. The color of the indicator
shows the status of the outlet. Green is on and Red is off. The power of each
outlet may be altered as follows: