Specifications


SLAS495A− JUNE 2006 − REVISED OCTOBER 2007
www.ti.com
56
REGISTER 07H: Temperature Min Threshold Measurement
BIT NAME
RESET
VALUE
READ/
WRITE
FUNCTION
D15−D13 0’s R Reserved
D12 TMNES 0 R/W Min Temperature (TEMP1 or TEMP2) threshold check enable for Auto/Non−Auto−Scan
Measurement.
0 => Min Temperature threshold check is disabled.
1 => Min Temperature threshold check is enabled.
Only valid for TEMP1 or TEMP2. Depends on bit TSCAN of control register 0CH/page 1 in case
of auto−scan measurement and depends on bits ADCSM of control register 00H/page 1 in case
of non−auto−scan measurement.
D11−D0 TTHRESL 000H R/W Temperature Min Threshold. When code due to temperature measurement goes below or equal to
programmed threshold value, interrupt is generated.
REGISTER 08H: AUX1 Max Threshold Measurement
BIT NAME
RESET
VALUE
READ/
WRITE
FUNCTION
D15−D13 0’s R Reserved
D12 A1MXES 0 R/W Max AUX1 threshold check enable for Auto/Non−Auto−Scan Measurement.
0 => Max AUX1 threshold check is disabled.
1 => Max AUX1 threshold check is enabled.
D11−D0 A1THRESH FFFH R/W AUX1 Threshold. When code due to AUX1 measurement goes above or equal to programmed
threshold value, interrupt is generated.
REGISTER 09H: AUX1 Min Threshold Measurement
BIT NAME
RESET
VALUE
READ/
WRITE
FUNCTION
D15−D13 0’s R Reserved
D12 A1MNES 0 R/W Min AUX1 threshold check enable for Auto/Non−Auto−Scan Measurement.
0 => Min AUX1 threshold check is disabled.
1 => Min AUX1 threshold check is enabled.
D11−D0 A1THRESL 000H R/W AUX1 Threshold. When code due to AUX1 measurement goes below or equal to programmed
threshold value, interrupt is generated.
REGISTER 0AH: AUX2 Max Threshold Measurement
BIT NAME
RESET
VALUE
READ/
WRITE
FUNCTION
D15−D13 0’s R Reserved
D12 A2MXES 0 R/W Max AUX2 threshold check enable for Auto/Non−Auto−Scan Measurement.
0 => Max AUX2 threshold check is disabled.
1 => Max AUX2 threshold check is enabled.
D11−D0 A1THRESH FFFH R/W AUX2 Threshold. When code due to AUX2 measurement goes above or equal to
programmed threshold value, interrupt is generated.
REGISTER 0BH: AUX2 Max Threshold Measurement
BIT NAME
RESET
VALUE
READ/
WRITE
FUNCTION
D15−D13 0’s R Reserved
D12 A2MNES 0 R/W Min AUX2 threshold check enable for Auto/Non−Auto−Scan Measurement.
0 => Min AUX2 threshold check is disabled.
1 => Min AUX2 threshold check is enabled.
D11−D0 A2THRESL 000H R/W AUX2 Threshold. When code due to AUX2 measurement goes below or equal to programmed
threshold value, interrupt is generated.