Instruction manual

©American DJ® - www.americandj.com - Mega Bar LED™ Instruction Manual Page 15
Mega Bar LED™ Trouble Shooting
Listed below are a few common problems the user may encounter,
with solutions.
Unit not responding to DMX:
1. Check that the DMX cables are connected properly and are
wired correctly (pin 3 is “hot”; on some other DMX devices
pin 2 may be ‘hot’). Also, check that all cables are connected
to the right connectors; it does matter which way the inputs
and outputs are connected.
Unit does not respond to sound:
1. Quiet or high pitched sounds will not activate the unit.
If problems are not resolved; Contact American DJ® for service.
1-800-322-6337
First unplug the power. The fuse holder is located next to the power
cord. Using a flat-head screw driver unscrew the fuse holder. Remove
the bad fuse and replace with a new one.
Mega Bar LED™ Fuse Replacement Mega Bar LED™ DMX Values and Functions - 7 Channels
Channel Value Function
1 0 - 255 RED
0% 100%
2 0 - 255 GREEN
0% 100%
3 0 - 255 BLUE
0% 100%
4 MACROS/PROGRAMS
0 - 14 OFF
15 - 28 RED
29 - 42 YELLOW
43 - 56 GREEN
57 - 70 CYAN
71 - 84 BLUE
85 - 98 PURPLE
99 - 112 WHITE
113 - 126 COLOR CHANGE
127 - 140 COLOR FLOW
141 - 154 COLOR DREAM
155 - 168 MULTI COLOR
169 - 182 DREAM FLOW
183 - 196 2 COLOR FLOW
197 - 210 COLOR CHANGE FADE
211 - 224 COLOR FLOW FADE
225 - 238 2 COLOR FLOW FADE
239 - 255 SOUND ACTIVE
5 SPEED/SOUND SENSITIVITY CONTROL*
0 - 255 SLOW FAST
6 STROBE
0 OFF
1 - 255 SLOW FAST
7 DIMMER
0 OFF
1 - 255 0 100&
*When the Channel 4 fader level is between the values of 15 and 236, the Channel 5
fader will control the speed of the macro/program.
When the Channel 4 fader is between 239 and 255 (Sound Active) the Channel 5
fadder will control the sound sensitivity level. Channel 5 will start at least sensitive to
most sensitive.
©American DJ® - www.americandj.com - Mega Bar LED™ Instruction Manual Page 16