Professional Power Amplifiers ����� ����� �� ������� ���� ����� ����� ��� ������ � �� ������� ����� � ������� ����� �� �� �� ���������������������������� �� ������� ���� ����� ����� ��� ������ � �� ������� ����� � ������� ����� �� �� �� ���������������������������� �� ������� ���� ����� ����� ��� ������ � AMERICAN AUDIO ® 4295 Charter Street Los Angeles Ca.
This symbol is intended to alert the user to the presence of non insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. This symbol is intended to alert the user of the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. CAUTION: Risk of the electrical shock - DO NOT OPEN! CAUTION: To reduce the risk of electrical shock, do not remove cover.
CAUTION Do not open risk of electric shock CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE COVER. THERE ARE NO USER SERVICEABLE PARTS INSIDE. REFER ALL SERVICE TO YOUR AUTHORIZED AMERICAN AUDIO® DEALER. The lightning flash with an arrow triangular symbol is intended to alert the user to the presence of non insulated “dangerous voltage” within the products enclosure, and may be of sufficient magnitude to constitute a risk of electric shock.
Important Precautions • To reduce the risk of electrical shock or fire, do not expose this unit rain or moisture • Do not spill water or other liquids into or on to your unit • Do not attempt to operate this unit if the power cord has been frayed or broken • Do not attempt to remove or break off the ground prong from the electrical cord.
���� ����� ����� ��� ������ � � �� CONTROLS AND FUNCTIONS 1 2 3 4 5 6 ������� ����� �� ���������������������������� FRONT PANEL 7 8 ������� ����� �� �� �� ������� ���� ����� ����� ��� ������ � 9 �� � 10 11 12 13 1. Power Switch - This switch controls the units main power. ����� 2. Channel 1 Limiter Switch (V2000 & V3000 Only) - This is used ������� ����� �� �� to activate the channels built-in limiter.
V1000 V1000plus REAR PANEL 1 2 3 PROFESSIONAL POWER AMPLIFIER INPUT CH 2 W WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK DO NOT EXPOSE THIS EQUIPMENT TO RAIN OF MOISTURE AVIS: A VIS: RISQUE DE CHOC ELECT ELECT-TRIQUE - NE P PAS OUVRIR.
V2000 V2000plus REAR PANEL 1 3 2 7 8 4 1 3 2 4 9 1. Cooling Fan Dual speed cooling fans. These fans are used to cool the internal parts of the amplifier. Never block the fan grills in any way or mount in an enclose rack, doing so may cause the amplifier to overheat and fail. 2. Channel 2 Input Connect the input source for channel two to either the balance XLR or the balanced/unbalanced 1/4” input jacks.
V3000 V3000plus REAR PANEL 1 2 3 5 4 6 1 3 2 4 7 8 9 1 Diagram 4 10 11 12 1. Cooling Fan - Dual speed cooling fans. This fans are used to cool the internal parts of the amplifier when in use. Never block the fan grills in any way or mount in an enclose rack, doing so may cause the amplifier to overheat and fail. 2. Channel 2 Subwoofer Mode On/Off Switch - This switch activates the amplifier subwoofer mode for channel two. 3. Channel 2 Frequency Adjustment.
Set Up INPUTS - The V Vplus series amplifiers allows you to use two types of input connectors per a channel, a XLR jack for balanced connections and a 1/4” female jack that will accept balanced and unbalanced connectors. Use these connections to connect the output signal from a mixer, cross-over or EQ to your V Vplus series amplifier. A balanced connection is recommended for cable runs longer that 20ft. When constructing your own XLR cables follow the pin configuration describe below for proper connections.
Bare Wire Connections: Diagram 10 When connecting your speakers to the amplifier using bare wire; Unscrew the red and black caps on the binding post, be sure not to completely remove or unscrew the red and black caps. Strip back the wire insulation 1/2” (13mm). Insert the bare wire into the hole that was reveled by unscrewing the binding post cap. After inserting the wire into the binding post hole, screw the binding post cap down on the wire.
Typical Stereo Output Connections V1000 V1000plus™ shown in illustration PROFESSIONAL POWER AMPLIFIER INPUT CH 2 CAUTION W WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK DO NOT EXPOSE THIS EQUIPMENT TO RAIN OF MOISTURE AVIS: RISQUE DE CHOC ELECTA TRIQUE - NE P PAS OUVRIR.
Typical Stereo Set-Up Diagram 15 Typical Mixer V3000 V3000plus series (Rear View) 1 3 2 4 Typical Speaker Connect to Vplus series Channel One Output American Audio® - www.americandj.
OPERATING MODES: Stereo Operation - Page 10/Figure 9 details an example of a typical stereo set-up. Connect your inputs into channels one and two of the amplifier. Connect your speakers to the outputs on the rear of the amplifier. Be sure that your front gain controls are turned down to their lowest level (full counter-clockwise). Turn your amp on. Turn your input source level up. Use your front gain controls to regulate the output volume.
goes into protect mode, the other side will continue to operate normally. During short circuit protection, the "Clip" LED and “Protect" LED will light simultaneously indicating amplifier fault. All channel output during the “Short Circuit Protection" will be interrupted (i.e. no sound output). Short Circuit Protection can usually be traced back to the signal output line (i.e. speaker line). Check the line from the output terminal of the amplifier to the speaker.
V-SERIES AMPLIFIER SPECIFICATIONS MODEL NO: Output Power: 2 ohms, 1 khz 1% THD 4 ohms, 1khz, 1%THD 8 ohms, 1khz 1% THD (Bridge Mode, mono) 4 ohms, 1khz, 1% THD 8 ohms, 1khz, 1% THD Total Harmonic Distortion: 20Hz-20kHz, @ rated output power, 8 ohms Input Sensitivity and Impedance: @ rated output power, 8 ohms Dimensions & Weight: Weight: Height Width Depth W Weight Frequency Response: +/- 1db, 1w RMS. 8 ohms +/- 0.2 db, @ rated output, 8 ohms V-1000 PLUS V-1500 315w RMS Per Ch. N/A 245w RMS Per Ch.
©American Audio® American Audio® is part American DJ® Group of Companies American DJ® World Headquarters: 4295 Charter Street Los Angeles, CA 90058 USA Tel: 323-582-2650 / Fax: 323-582-2610 web: www.americandj.com / e-mail: info@americandj.
