User guide

PITCH ADJUSTMENTS
©American Audio® - www.AmericanAudio.us - Velocity Mp3™ Instruction Manual Page 29
2. PITCH BENDING:
Unlike the PITCH SLIDER (
36) adjustment this function will momentarily increase or decrease a tracks
speed during playback. There are two ways to operate this function with the (-) & (+) PITCH BUTTONS (26 &
27) or with the JOG WHEEL (24). The maximum pitch bend percentage allowed is +/- 100%. The pitch bend
function will work in conjunction with the PITCH SLIDER (36)
pitch setting. For example, if the PITCH SLIDER
(36) is set to a 2% pitch gain the pitch bending process will begin at 2% and will continue to the maximum
of +
/- 100%.
NOTE: A -100% pitch manipulation will stop playback entirely.
Holding down or tapping on the (-) PITCH BEND BUT-
TON
(26) will provide a slow down in the playback
pitch.
Figure 44
Adjusting the PITCH SLIDER'S RANGE: You may change
the PITCH SLIDER'S (36) operating range at any time. To change
the operating range be sure the pitch function is turned on, see
figure 42. The pitch percentage can be changed between +/-4%,
+/-8%, +/-16%, and +/- 100%. 4% will allow the least amount of
pitch manipulation and 100% will allow the most amount of pitch
manipulation. To adjust the different values, press and hold down
the PITCH ON/OFF BUTTON (35) and Tap on the + PITCH BEND
BUTTON (27) until your desired value is reached. Note, the pitch
percentage must be activated to get a LED reading.
Figure 45
Holding down or tapping on the (+) PITCH BEND BUTTON
(27) will provide a speed bump in the playback pitch.
Figure 46