User guide

©American Audio® - www.americanaudio.us - VMS2™ Instruction Manual Page 13

FRONT PANEL - GENERAL FUNCTIONS AND CONTROLS

FRONT PANEL -







Turns the corresponding microphone on/off. When you Mic is on the button will

be backlit by a red LED.

Increase or decrease the microphone signal level.

Adjust the vocal tone on the corresponding Mic inputs.







These will switch the corresponding Channel from USB audio stream

or analog audio input. USB will route the software assigned ASIO audio channel thru the corre-

sponding MIDILOG channel. Analog will route the analog audio input from the rear panel thru the

corresponding MIDILOG channel.

Switches the crossfader from normal to reverse

mode. In reverse mode the CF A assignments will be on the right of the crossfader and the CF B on

the left.

Sets the headphone output from Cue or Master. When set to the Cue

position, the headphones will receive the signal from any and all channels with the Cue button acti-

vated. When set to the Master position, the headphones will receive the pre fader master output

signal, allowing you to cue the master at any output level and even if it is fully off. Any knob settings

in between Cue and Master will blend the Cue and Master signals.

Will set the output level of the headphones.

Connect your headphones to this jack. The headphone signal is con-

trolled by the controls described previously.

This knob will adjust the curve of the crossfader from mix curve, dipped curve,

to scratch curve.

21 22 23 24 25 24 26 27 28