User guide

©American Audio® - www.americanaudio.us - VMS2™ Instruction Manual Page 18
EQ MODES
Post EQ is for users who prefer using the EQ from their software. To toggle the post EQ mode on
and off; before powering up the VMS2, press and hold the    on
control deck 2 and then power "ON" the unit. Release the button, your computer may reinstall the
VMS2 as a new device, please allow 10-20 seconds for the change to take place. Confirm the EQ
change by checking the ASIO Driver configuration. The first number in the sequence will be a "1" in
this mode. Please see the window below.
Make sure you are using software where you can map the MIDI from the EQ and that the EQ has
been mapped when using this mode.