Installation Guide

10
  I F G  & G 



ocate the clear door sweep and attach it to the bottom of the glass door he
reflectie shield should face into the shower
dia  The oor ee  ht ee
the oor oe djust the door seal until the reuired tension is achieed he door
sweep has been cut to fit oer the hinge ut off the ecess length opposite of
hinge side
e hae proided door seals for water sensitie areas such as wood floors f glass
panels and door are installed correctly with the proper spacing, outside water
spillage will be minimal and the side seals wont be necessary
f you would lie to use these side seals, follow the steps below
 he  shaped seal goes along the hinge side of the door on the threshold trim
pieces dia 






lace the seal along the edge of the glass and cut the seal to the proper
length
emoe the bacer from the seal eposing the double-sided tape, only remoe
a small amount at a time
tarting from the top, align the seal along the edge of the door and stic the
seal to the threshold
or your way down the door o small sections at a time, slowly peeling the
bacer off the seal
ocate the plastic h-shaped seal
  t goes on the fied glass, net to the
handle edge
dia  easure and cut the seal to length
tarting from the top, push the seal onto the glass panel, slowly woring your
way down
diaram 
lass
oor
to inside
of shower
o eep door
closed adjust height
of door sweep to
proide proper
tension and seal

hower hreshold
diaram 
glass
panel
strie
side
door
hinge
side
inside shower
outside shower
D



side wall
casing
top hinge
pin bracet
/ pin hole
 
pan threshold
C   F G  & G 
 ently insert the side glass panel into the channels ou will be adjusting the fied
glass panel so its leel with the door and has an een  gap between the door
and the glass panel se rubber setting bloc to adjust height and leel if necessary
 et, to determine the position of the bottom hinge pin hole, place the top hinge
pin bracet upside down on bottom pan threshold as a template
dia.  lign
bracet hole to center of side glass panel ar the hole and remoe the bracet
arefully drill  dia hole for hinge pin approimately  deep into the threshold
 ic up the door you hae installed the hinges and handle onto, and gently place
the bottom hinge pin into the / hole you hae drilled into the pan threshold
maing sure you hae the eflon slide washer on the pin
ith someone helping to hold the shower door, place the top hinge mounting
bracet
dia  oer the top hinge pin maing sure you hae the eflon slide washer
on the pin hec to mae sure door is plumb and leel, then mar with a pencil
through the  holes on top hinge mounting bracet
oe door and top hinge mount to one side and pre-drill the holes into the studs
he drilled holes should be large enough so the screws dont bind in the stone
nsert and tighten screws
et dry-fit the fied panel into the correct alignment with the door, remoe the
glass and apply a / bead of   silicone into the channels e-insert the
fied glass panel and chec alignment again llow the silicone to dry ou can
silicone any gaps between the stone and glass to ensure water tightness
E  I  S & S
h-seal
-seal
hinge
pin
side
plate


side
plate
hinge
pin




eflon slide
washer
teflon slide
washer
hinge wall
bracet
screw
 places

