Installation Guide
orner helf nstall uide
eel
auling un ilicone
rill it
horoughly clean the surface on which the shelf will be adhered
lan height for installation of the shelf ry fit the shelf and sand the bac edge
as needed to allow for a good fit
ou can install the shelf with silicone or the screws included
a oe tto pply silicone to the bac edge of shelf and
press rmly in place applying een pressure ou may use painters
tape to help hold it in place while it dries llow to dry for hours
b re tto irst, place your shelf in desired location se a
pencil to mar the mounting holes et, drill out the pilot holes nsert
the anchor through pilot holes, apply silicone to bac edge of shelf
and then screw shelf to wall
nce silicone has fully cured, apply a bead of silicone caul around the
perimeter of the shelf to seal out water se a wet finger to smooth the caul
and then clean off ecess with a damp sponge
llow to fully dry before use
Back edge of shelf
NT
hen figuring out the proper height for your shelf, its a good idea to consider eeryone that will use the shower
eriodically chec the silicone and caul for any wear or deterioration and correct as necessary
Tooue
encil
rill
ainters ape
aul
hillips ead crewdrier
ponge
lean loth
ine rit andpaper
TOO ND O ND TO NT O O
o / for some installs you may need mil water/apor barrier plastic sheeting
o
o powdered non-sanded with additie for adhesion or pre-mied non-sanded
o
o
o / /
o
o or
o iamond ip recommended
o
o /
o
o
o
o
o /
o
o
o
o
o
o
o
o
o
o
stelle treet, orona, alifornia
hone a
isit us at wwwamericanbathfactorycom
14