Installation Guide
his shower system is designed to be installed on a leel, bare floor t is necessary for any eisting shower to be
completely remoed ear out and remoe all old material to epose the wall studs lean up the shower
area, remoing all dust and old material from the area
o ether r e recommend not installing your shower below the temperature of he shower
will be fine in cold weather after installation, but during installation bending and handling shower components
in cold weather can cause breaage rigid conditions can mae some shower components brittle and
susceptible to cracing during rough installation handling
DTTN T N
to
/ cement board
stud
metal flange
pan
diaram
floor of pan
silicone bead
t is easier to chec alignment of studs and pan without the
drain installed into the pan
lace the pan in the planned position hec to see that
the spacing between the metal pan flange and studs
are flush ome shimming or sanding of the studs may
be reuired to flush the studs with the metal pan flange
hen screwing in the / cement board the metal flange
will pull fast to the studs, and will secure the metal pan in
place dia.
D