Installation Guide



NT OD NTTON
 
 
apply silicone
diaram 
e recommend the use of / thic cement board as your shower bacer his is a common bacer for stone
and tile sing this bacer will help comply with almost all city codes  cement-based product lie
onderoard or ardieacer may also be used if it meets your local codes ome codes reuire a apor
barrier to be installed as well e recommend a water/apor barrier of  mil plastic be installed before installing
the cement board o do this, staple plastic so that it hangs  aboe the floor oofing nails may be used to
attach the cement board instead of screws, this preents the plastic from wrapping around the screws
OTNT se your cement board as an indicator of suareness he
cement board comes in suare sheets f you see gaps or areas where the
cement board is not fitting flush, fi the problem by remoing the cement
board and shimming the board until its suare and flush f the seams of the
cement board are not flush and suare, your wall panels will not be suare
and flush
 ut a notch in cement board to fit around threshold flange anding or
shimming the   s at the top rim of the pan may be reuired to flush the
cement board dia 
 lace a bead of   silicone on the front  face of the shower
pan flange he bead should be in a ig-ag pattern dia 
 lace the cement board against the studs and rest it inside the shower
pan against the bac flange ttach the cement board to the studs with
screws or nails DO NOT screw or nail into the metal shower pan flange
 ontinue installing the remaining cement board
notch
diaram 

TTN N
 
 
 ow that the drain is installed into the pan dry fit the pan and drain for
alignment, chec to mae sure the  drain pipe is in the center of the pan
drain hole dia.  se the drain collar  by itself remoe the rubber seal,
nut and gasets from the drain assemblydia. , reious ae ush the
drain collar  into the drain hole between the pan and the  pipe ith
the drain collar pushed flush to the pan surface, the  drain pipe should
not etend past the inside threads of the drain collar 
 ae sure the pan and drain fit leel to the floor
 emoe pan and apply   ilicone to floor dia 
 arefully lift the shower pan and set into place ae sure the  pipe is
still centered
 ush and secure the rubber seal  onto the   pipe
 hread on the brass pressure ring  around the drain pipe with the
proided tool  emoe the tool after the brass pressure ring is installed
 est and snap the decoratie diamond trim plate  into positionemoe
the decoratie trim plate and store in secure area until installation is complete,
dr
ain will be grouted when shower is grouted

 fter installing pan, coer with cardboard or drop cloth to protect pan
from scuffs
silicone