Installation Guide
NN NTTON
A I W L
nspecting panels at this point will gie you confidence that the wall panels are straight and suare from the
factory hen installing wall panels, you may need to mae adjustments to the panels to accommodate for
uneenness of your eisting walls uring the inspection process and/or dry-fitting process, if you hae any
concerns about the alignment or fit of the wall panels, please call us and we will gladly assist you with your install
ind a large flat area to layout and inspect all panels
lign all panels and liners to chec for straightness ae sure grout lines are straight and suare to each
other
istine tone wall panels are made to be fleible and may hae a slight bow his condition is normal and wall
panels will flatten out when properly installed f wall panels hae been stored improperly or hae become
ecessily bowed, they can be corrected before installation
ee troubleshootin section on last ae or details
B W L
lace your first bottom bac panel
into position dia est onto the
pan floor use spacers between the floor and the panel to mae the top of
the panel leel
lace the bac liner into position ae sure the grout lines are aligned,
use spacers to mae the top leel nspect the spacing between the wall
panels and the side threshold plumb line
lace the top panel
into position, push the two panels together ae
sure the grout lines are aligned, use spacers to mae the top of the panel
leel nspect the spacing between the wall panels and the side threshold
plumb line
epending on your cement board alignment, some sanding of the wall
panel edges may be reuired for a tight fit
S No you he for
eee rout e et etee u e
diaram
diaram
olding the upper panels and liner in place with another persons help,
chec the length and oerlap alignment ome fitting may be reuired
lace one of the bottom side panels into position and chec for
leelness and length
lace the side liner into position dia
lace one of the top side panels
into position
epeat steps through for other side of shower
epending on your faucet selection, you may need to mar and cut
out holes for your faucet and other accessories
ie shampoo shelf to fit
through before you can place the panel into position emember
measure twice, cut once, you can cut our walls with most cutting tools
T