Installation Guide


hinge
pin
side
plate


side
plate
hinge
pin




teflon slide
washer
teflon slide
washer
hinge wall
bracet
screw
 places






pply a generous amount of silicone onto the hinge and side plate
osition the hinge onto the glass door lining up the holes so that the screws are
on the inside of the shower door
ttach the side plate with silicone applied to the glass and tighten the screws
until the hinge is secure ipe off the ecess and allow to dry
epeat these steps for the bottom hinge
ou will also find a inyl ater hield for the bottom hinge his can be added
in between the glass door and the side plate to help eep water in the shower
should you hae a smaller shower or a shower-head pointed towards the door
dia a ee mages below for illustrated installation eamples ou may trim
the ater hield as needed
9
A  H I
 et the glass door in a position to enable the assembly of the handle
 oosen the set screws so you can separate the handles



nscrew the long bolt from the handle eep all rubber pieces attached to
the screw
emoe the first set of flat, clear washers from the bolt
tart with the top hole on the glass door lace the long bolt through the hole
in the
door eeping the remaining rubber pieces on the bolt n the other side of
the glass place the flat washers onto the threaded portion of the bolt dia 




diaram 
clear washer
clear
spacer
clear
washer
set screw
shower
inside
shower
outside
e refu ot to ret the ee of the oor o hr urfe Teere  
ery tro  t rett ut t eet ot  t o the ee
bolt
D
D

ae one side of the handle and screw the long bolt into the end ust start the
bolt until a few threads catch eep loose dia 
ut the second bolt through the lower hole lace the flat washer onto the
bolt crew the bolt into the bottom handle dia 
lign the handle on the door and carefully tighten the long bolts o not oer
tighten
lace the opposite handle oer the long bolts and tighten the set screws to
secure the handle
B  H I
ocate the top hinge

and remoe the side plate by loosening the two
screws
dia 

inyl water shield
 
side
plate
 DOO ND  N NTTON