Installation Guide

9a
hinge
pin
side
plate
diagram
14
side
plate
hinge
pin
inside
shower
outside
shower
1.
2.
3.
4.
5.
6.
7
A - Handle Installation
1. Set the glass door in a position to enable the assembly of the handle.
2. Loosen the set screws so you can separate the handles.
3.
4.
5.
6.
7.
8.
9.
diagram 13
clear washer
clear
spacer
clear
washer
set screw
shower
inside
shower
outside
screw
DH
DH
Unscrew the long bolt from the handle. Keep all rubber pieces attached to the
screw.
Remove the first set of flat, clear washers from the bolt.
Start with the top hole on the glass door. Place the long bolt through the hole in
the door (keeping the remaining rubber pieces on the bolt). On the other side of
the glass place the flat washers onto the threaded portion of the bolt. (dia. 13)
Take one side of the handle and screw the long bolt into the end. Just start the
bolt until a few threads catch. Keep loose. (dia. 13)
Put the second bolt through the lower hole. Place the flat washer onto the bolt.
Screw the bolt into the bottom handle. (dia. 13)
Align the handle on the door and carefully tighten the long bolts. Do not over
tighten.
Place the opposite handle over the long bolts and tighten the set screws to
secure the handle.
B - Hinge Installation
Locate the top hinge
GH
and remove the side plate by loosening the two
screws. (dia. 14)
Apply a generous amount of silicone onto the hinge and side plate.
Position the hinge onto the glass door lining up the holes so that the screws are
on the inside of the shower door.
Attach the side plate with silicone applied to the glass and tighten the screws
until the hinge is secure. Wipe off the excess and allow to dry.
Repeat these steps for the bottom hinge.
You will also find a Vinyl Water Shield for the bottom hinge. This can be added
in between the glass door and the side plate to help keep water in the shower
should you have a smaller shower or a shower-head pointed towards the
door. (dia. 14a) See Images below for illustrated installation examples. You may
trim the Water Shield as needed.
GH
vinyl water shield
diagram 1 4a
side
plate
HINGED DOOR INSTALLATION
SKIP THIS SECTION FOR NO GLASS OR SLIDING DOOR
TIME
½ to 1 HR
Be careful not to rest the edges of the glass on hard
surfaces. Tempered glass is very strong and impact
resistant but its weakest point is impact on the edges.