Installation Guide

ManualsBrandsAmerican Bath Factory ManualsCorner Shower KitsK-N363680ME-CH

OPTIONAL SHAMPOO SHELF INSTALLATION

TIME REQUIRED

1/2 - 1 HR

4. On the 2 tiles the Shampoo Shelf will be replacing, mark 1”

from the outside of the grout line, the cut-out area will be

10” x 22”. Cut out the hole for the Shelf. The smaller the

hole the better.

5. Dry-ﬁt the Shampoo Shelf for alignment of grout lines.

6. Silicone in-place with a generous bead around the back of the

lip, wipe off excess silicone with tissue.

1. The Shampoo Shelf was designed to fit between two studs,

the cut-out hole size is 10 x 22”.

2. There is a 1” lip or frame around the Shampoo Shelf, this will

be the water sealed area for the Shampoo Shelf.

3. The best way to cut the hole is with a small 5” round

diamond blade, and with a jigsaw to cut the corners.

See detailed instructions enclosed with Shampoo Shelf

DOOR HANDLE, HINGE, PANEL, DOOR & HEADER INSTALLATION

A - Door Handle Installation

1. Set the glass door in a position to enable the assembly of the handle (diagram 18)

2. Loosen the set screws so you can separate the handles.

3. Unscrew the long bolt from the handle. Keep all rubber pieces attached to the screw.

4. Remove the ﬁrst set of ﬂat, clear washers from the bolt.

5. Start with the top hole on the glass door. Place the long bolt through the hole in the door

(keeping the remaining rubber pieces on the bolt). On the other side of the glass place the ﬂat

washers onto the threaded portion of the bolt.

6. Take one side of the handle and screw the long bolt into the end. Just start the bolt until a few

threads catch. Keep loose.

7. Put the second bolt through the lower hole. Place the ﬂat washer onto the bolt. Screw the bolt

into the bottom handle.

8. Align the handle on the door and carefully tighten the long bolts. Do not over tighten.

9. Place the opposite handle over the long bolts and tighten the set screws to secure the handle.

clear washer

clear spacer

clear washer

set screw

shower

inside

shower

outside

diagram 18

B - Hinge Installation (pre-installed on Door)

1. Locate the top hinge and remove the side plate by loosening the two screws.

(diagram 19)

2. Place the hinge into the top cutout on the door so the screws will be facing into the shower

and install the side plate. Tighten the screws until the hinge is secure. Make sure the hinge is

centered in the cutout and that the screws are facing into the shower.

diagram 19