Installation Guide

5
2 x 4 STUDS ALIGNMENT & POSITIONING
TIME REQUIRED
½ to 1 HR
6
INSTALLING MATCHING DRAIN ASSEMBLY
TIME REQUIRED
½ to 1 HR
1. Locate the drain assembly to install into pan
2. Apply a generous bead of silicone around the shower pan drain hole and around the outside of
the drain collar #5, insert the drain collar #5 into the drain hole.
3. Apply a generous bead of silicone around the drain collar #5 from the underside of the pan.
4. Install the rubber gasket #6 over the drain collar #5, to the underside of the pan, next install the
slide ring #7.
5. Screw on the drain lock nut #8 and hand tighten. Turn drain lock nut #8 approximately 1/4
turn with the wrench to ensure a water-tight fit. Check for a good seal. DO NOT OVERTIGHTEN.
6. Wipe off excess silicone and allow silicone to dry. Follow the manufacturer’s directions for
application and drying time.
SEE SILICONE RECOMMENDATIONS PAGE 8
4
#1 trim plate
#2 drain tool
#3 pressure ring
#4 rubber seal
#5 drain collar
pan
#6 rubber gasket
#7 slide ring
#8 drain lock nut
apply silicone
around drain collar
sides and under lip
floor hole with
2” drain pipe
diagram 3
17
G7 P1
Using the pan and and wall panels, you will be able to check to make sure your 2 x 4 studs are in the needed position and supported
adequately. You will see in (diagram 2) extra 2 x 4 studs are added to the door and glass side thresholds for extra strength. You may need to make adjust-
ments for your faucet or optional shampoo shelf. When you place the bottom sections of the wall or into the shower pan , you can also
calculate the needed width and height of areas to keep free of 2 x 4 studs. (See installation instructions included with the faucet or shampoo shelf)
P1 W1 W2
W1 W2 P1