Installation Guide

6
PAN & WALL THRESHOLD TRIM
TIME REQUIRED
1/2 - 1 HR
9
diagram 10
diagram 11
cement
board
diagram 9
diagram 6
diagram 8
floor trim
metal pan
door rail
A - Pan Threshold
1. Locate the 2 rail pieces (diagram 6) (diagram 7)
2. Dry fit onto the front of the metal pan . the door rail is 1” shorter than
the panel channel rail. The door rail is reversible and can be placed on the left or right.
(diagram 8)
3. Remove and place silicone on bottom of rails and in bottom channels, re-install.
4. The floor trim pieces are usually installed at the end of the installation. Depending on the
thickness of your bathroom floor, will determine how you place the floor trim. The floor trim
can be placed 3/4” high or 1” high depending on your floor thickness, the pieces can be
trimmed if needed.
B - Wall Threshold Trim
1. Locate door side thresholds.
2. Locate panel channel side thresholds & cap.
2. To help with the side threshold installation, use a level and draw a plumb line from the inside of
the pan threshold up to the top of the shower. Do this on both sides. This line will be where
the side rails and the wall tiles meet, this will give you a visual reference point when dry-fitting
your wall tiles.
3. Apply silicone, using a circular pattern, to the cement board along the plumb line,
approximately 4 inches wide, to the edge of the shower pan. (diagram 10)
4. Place the first side threshold into position, making sure to align the side rail with the vertical
plumb line previously drawn on the cement board. Apply pressure to the side threshold to bond
it to the cement board. The side threshold will flush with the inside of the shower pan threshold
and have a small gap where the pan threshold slopes. (diagram 11)
5. Place the remaining side thresholds into position, 3 to each side. Make sure to use a level and
the plumb line previously drawn on the cement board to align the side thresholds vertically.
silicone
P2
P1
P4
diagram 7
floor trim
metal pan
panel channel rail
silicone
P3
P1
P4
P2 P3
P2 P3
P1 P2
P3
P2
P4
P4
metal pan
P1
floor trim
P4
door rail
P2
panel channel rail
P3
door side thresholds (3)
panel channel side
thresholds (3) & cap
W5
W6
W5
W6
silicone-
circles