Installation Guide

SLIDING GLASS DOOR INSTALLATION
11
Be careful not to rest the edges of the door on hard
surfaces. Tempered glass is very strong and impact
resistant but its weakest point is impact on the edges.
TIME REQUIRED
1/2 - 1 HR
Our glass is tempered to make for a very strong door, the tempering gives maximum strength from impact on the surface, unfortunately this make the glass
very vulnerable to breakage from impacts to the bottom and top edges of the glass panel. Do not rest the top or bottom of glass panels on hard floor or objects,
always keep corner pads on glass while handling. Place foam or a soft material under the glass panel when unpacking and setting aside
CONTENTS
fixed glass panel
SLIDING GLASS
DOORS
FIXED GLASS
PANELS
DOOR SLIDE BRACKETS
45
°
DOOR SEALS
panel channel
side thresholds
A - Fixed Panel Installation
1. Locate the Fixed Glass Panels , Door Slide Brackets , and Clear Silicone.
sliding
glass
doors
fixed glass panel
wheel
diagram 17
door slide
bracket
45
°
door seals
cement board
door bumper for thresholds
36”and smaller
2. Dry fit the Fixed Glass Panels in place. Place the fixed glass panes linto the
panel channel side thresholds , there are no channels for the pan top rails,
silicone will hold the glass panels to the pan top rails.
3. Now that you have dry-fitted your panels, remove panels and silicone in place. Place
a small bead of Silicone in the channels of the wall thresholds and pan top rails.
Silicone where the Fixed Glass Panels will rest, don’t silicone past where the Fixed
Panel ends. Push the Fixed Glass Panels into their resting position and clamp in
place until the silicone is dry. Wipe off any excess silicone with tissue paper.
10
SHOWER DOOR WHEELS
DOOR BUMPERS
FOR THRESHOLDS 36”
AND SMALLER
DOOR CHANNEL BUMPERS
FOR THRESHOLDS LARGER
THAN 36”
wheel
door channel bumper for
thresholds larger than 36”
12
G15
G13
G14
G12
G1
G2
G2
G11
G2
W6
panel channel
side thresholds
W6
W6
G2
G2
G1
G11
G14
G14
G15