Installation Guide

ManualsBrandsAmerican Bath Factory ManualsCorner Shower KitsSonoma Sistine Stone Wall Stone Composite Floor Rectangle 11-Piece Corner Shower Kit (Actual: 80-in x 38-in x 38-in)

WALL PANEL/LINER INSTALLATION

TIME REQUIRED

3-4 HR

A - Inspecting Wall Panels/Liners

Inspecting panels at this point will give you conﬁdence that the wall panels are straight and square from the factory. When installing wall panels, you may need to

make adjustments to the panels to accommodate for unevenness of your existing walls. During the inspection process and/or dry-ﬁtting process, if you have any

concerns about the alignment or ﬁt of the wall panels, please call 1-800-454-2284 for customer service, and we will gladly assist you with your installation.

1. Find a large empty area to layout and inspect all panels.

2. Align all panels and liners to check for straightness. Make sure grout lines are straight and square

to each other.

3. Sistine Stone wall panels are made to be ﬂexible. (Warning - Store on a ﬂat area.) If wall panels

have been stored improperly or seemingly have become extensively bowed, they can be easily

ﬂattened before installation (See troubleshooting section on last page for details).

B - Test Alignment by Dry-ﬁtting Wall Panels/Liners

1. Place your ﬁrst bottom panel into position. (diagram 11). Rest panel onto the pan

ﬂoor; use spacers between the ﬂoor and the panel to make the top of the panel level.

2. Place the second bottom panel into position, push the two panels together. Make sure the

grout lines are aligned, use spacers to make the top of the panel level. Inspect the spacing

between the wall panels and the side threshold plumb line.

3. Depending on your cement board alignment, some sanding of the wall panel edges may be

required for a tight ﬁt.

4. Place liners in position check for level and length.

5. Place RT liner into position. (diagram 12)

6. Place LT liner into position. Depending on your faucet selection, you may need to mark

and cut out holes for your faucet to ﬁt through before you can place the panel into position.

Remember “measure twice, cut once”, you can cut our walls with most cutting tools.

(See installation video at www.americanbathfactory.com). Now you can check for level, grout

line alignment and spacing between walls and plumb line.

diagram 11

diagram 12