Installation Guide

WALL PANEL/LINER INSTALLATION (continued)

TIME REQUIRED

3-4 HR

C - Installing Panels

8. Sand the backside surface of the wall panels with 60 grit sandpaper. This will increase the bond

to the silicone. Remove all dust and dirt with a clean dry cloth.

9. Start with panel , apply a generous amount of silicone to the cement board and to the

back side of the wall panel. Refer to “Silicone Recommendations” on previous page for

applying silicone. Also refer to the manufacturer’s recommendations for application and drying

time.

10. Press the wall ﬁrmly into position. Be sure to use spacers between the bottom panel and the

shower pan to ensure panel is level. (diagram 16)

11. Install the remaining panels in the following order:

Match the space between the panels with the rest of the grout lines on the panel. Use spacers if

necessary to make the walls square and straight.

B races may be required to keep walls ﬂush

diagram 16

OPTIONAL SHAMPOO SHELF INSTALLATION

TIME REQUIRED

1/2 - 1 HR

4. On the 2 tiles the Shampoo Shelf will be replacing, mark 1”

from the outside of the grout line, the cut-out area will be

10” x 22”. Cut out the hole for the Shelf. The smaller the

hole the better.

5. Dry-ﬁt the Shampoo Shelf for alignment of grout lines.

6. Silicone in-place with a generous bead around the back of the

lip, wipe off excess silicone with tissue.

1. The Shampoo Shelf was designed to match your tile size.

(2) 12” x 12” tiles, the cut-out hole size is 10 x 22”.

2. There is a 1” lip or frame around the Shampoo Shelf, this will

be the water sealed area for the Shampoo Shelf.

3. The best way to cut the hole is with a small 5” round

diamond blade, and with a jigsaw to cut the corners.

See detailed instructions enclosed with Shampoo Shelf