Installation Guide

wheel
inside bracket
outside bracket
shower door
bolt
11
diagram 18
clear washer
clear
spacer
clear washer
shower
inside
shower
outside
B - Handle Installation
1. Set the glass door in a position to enable the assembly of the handle (diagram 18)
2. A left door will have the Door Handle on the left, a right door will have the Door Handle
on the right.
3. Loosen the set screws so you can separate the handles.
4. Unscrew the long bolt from the handle. Keep all rubber pieces attached to the screw.
5. Remove the first set of flat, clear washers from the bolt.
6. Start with the top hole on the glass door. Place the long bolt through the hole in the door
(keeping the remaining rubber pieces on the bolt). On the other side of the glass place the flat
washers onto the threaded portion of the bolt.
7. Take one side of the handle and screw the long bolt into the end. Just start the bolt until a few
threads catch. Keep loose.
8. Put the second bolt through the lower hole. Place the flat washer onto the bolt. Screw the bolt
into the bottom handle.
9. Align the handle on the door and carefully tighten the long bolts. Do not over tighten.
10. Place the opposite handle over the long bolts and tighten the set screws to secure the handle.
screw
set screw
diagram 20
Sliding
Glass
Door
Fixed
Glass
Panel
top slide bracket
clear rubber insert
slide
diagram 19
C - Sliding Glass Door Installation
1. Locate the shower door wheels
2. To install the wheels on the sliding glass door, unscrew the bolt from the inside bracket.
Place the outside bracket on the outside of the door, and place the inside bracket and wheel into
the cutout section of the shower door (diagram 19) Push the bolt through the inside bracket
until it screws into the outside bracket. Repeat for the remaining wheels.
3. After 30 minutes to an hour the silicon on the fixed glass panel should be secure enough to
finish the door assembly. (do not use excessive force on the door until the silicone is fully dried).
Have the top slide bracket handy and ready to install. Carefully place the Door into position, with
the wheels resting in to the pan threshold channels facing into the shower.
4. To secure the sliding door to the door slide bracket (diagram 20) Take the clear rubber
insert of top bracket and put a pea drop of silicon inside of channel then place on the top end of
the Fixed Glass Panel. Next lower the bracket over the clear rubber insert at the same time
making sure the glass is going into the guide channel, push down leaving a 1/8” gap between
top of the Sliding Glass Door and the slide. (pushing the slide bracket down to far will create
to much friction for the door to move easily).
5. To install the two rubber door stops, place a drop of silicon onto the rubber stops, and position
on the left and right wall thresholds, in the center of where the door will stop.
G3
G3
G12
G12
G11
G11