Owner manual

American Bicycle Security Company
P.O. Box 7359
Ventura, CA 93006
Ph: [phone] or [phone]
Fax: [phone]
www.ameribike.com
Email: [e-mail]
Rolling Rack
Product
Broadway Rack
Capacity
BR2H: 5 Bikes
BR3H: 7 Bikes
BR4H: 9 Bikes
Materials
2.375” OD Schedule 40 pipe
Finishes
An after fabrication hot dipped galvanized finish is our standard
option.
250 TGIC powder coat colors, thermoplastic coating, PVC dip,
and stainless steel finishes are also available as alternate
options.
Our powder coat finish assures a high level of adhesion
and durability by following these steps:
1. Sandblast
2. Epoxy primer electrostatically applied
3. Final thick TGIC polyester powder coat
Stainless Steel: 304 grade stainless steel material finished
in either a high polished shine or a satin finish.
Installation
Methods
In ground mount is embedded into concrete base. Specify
in ground mount for this option.
Surface mount has two 5.25” x 5.5” foot plates with
4 anchors per foot. Specify foot mount for this option.
A rail mounted (freestanding) option is also available.
Space Use
& Setbacks
Wall Setback: A minimum of 27” should be left between the
wall and the long side of the rack. 36” is the recommended
setback.
Street Setback: For racks set parallel to the street, a 98”
setback is recommended. For racks installed perpendicular to
the street, 24” is the minimum setback. 36” is recommended.
Between Racks: For racks set next to each other, 24” is the
minimum setback. 36” is recommended.