Manual

ManualsBrandsAmerican Bicycle Security Company ManualsFor bicyclesCampus Rack

The design of the Campus

rack supports both the

wheel and frame of the

bike, and university

campuses love its orderly

and efficient bike parking.

The single sided model

keeps bikes parked on one

side of the rack, making it

ideal for sidewalk

placement. The Campus

Rack’s complete welded

construction means easier

installation, and thieves

cannot disassemble the

rack.

American Bicycle Security Company

P.O. Box 7359

Ventura, CA 93006

Ph: (800) 245-3723 or (805) 933-3688

Fax: (805) 933-1865

www.ameribike.com

Email: turtle@ameribike.com

Campus Rack

Summary of content (4 pages)

PAGE 1
Campus Rack The design of the Campus rack supports both the wheel and frame of the bike, and university campuses love its orderly and efficient bike parking. The single sided model keeps bikes parked on one side of the rack, making it ideal for sidewalk placement. The Campus Rack’s complete welded construction means easier installation, and thieves cannot disassemble the rack. American Bicycle Security Company P.O. Box 7359 Ventura, CA 93006 Ph: (800) 245-3723 or (805) 933-3688 Fax: (805) 933-1865 www.
PAGE 2
Campus Rack Product Campus Rack Capacity 3-11 Bikes Materials Centerbeam: 3” OD 7 gauge tube Ears: 1.25” OD 11 gauge tube. All welds to be continuous MIG welds Finishes An after fabrication hot dipped galvanized finish is our standard option. 250 TGIC powder coat colors, thermoplastic coating, PVC dip, and stainless steel finishes are also available as alternate options. Our powder coat finish assures a high level of adhesion and durability by following these steps: 1. Sandblast 2.
PAGE 3
Campus Rack Surface Mounted Installation *Tools Needed for Installation Tape Measure Marker or Pencil Masonry Drill Bit Drill (Hammer drill recommended) Hammer Wrench 9/16” Level 1. 2. Drill hole 3” Deep Recommended Base materials: Solid concrete is the best base material for installation. To ensure the proper anchors are shipped with your rack, ask your American Bicycle representative which anchor is appropriate for your application.
PAGE 4
Campus Rack In-Ground Mounted Installation *Tools Needed for Installation Level Cement mixing tub Shovel Trowel Hole coring machine with 4” bit Access to water hose Materials to build brace Installing into Existing Concrete 2. Place rack into holes, making sure it is level 1. Installing into New Concrete 1. 2. Place corrosion resistant sleeve (min. 3" inside diameter) in sand pour bed in exact location where rack will be installed.