User Guide

VOLTEX 50 RV PLUS
13
Troubleshooting
If you have a good voice signal and fast data speeds even though one or two of LEDs are solid red,
you may continue to use the Signal Booster as it is.
However, if one of the LED’s has ashing or solid red, your voice signal is weak and data speeds are low,
then follow the troubleshooting steps below.
1. Unplug the Signal Booster’s power adapter.
2. Check if the Outside Antenna and Inside Antenna are located a minimum distance of 20 feet
from each other.
3. Plug the Signal Booster into a power source.
4. Check the LED on the Signal Booster. If ashing or solid red appears, repeat steps 1 through 3 and
relocate Inside and Outside Antennas.
5. If you have any diculties with installation or troubleshooting the Signal Booster, please contact
our technical support team for assistance (Tel. : [phone]).
LED’s O
1. If none of the LEDs on the Signal booster are lit, verify that the signal booster is connected
properly to the AC/DC power adapter cord and then verify that the power adapter is plugged
into a live AC outlet in your vehicle.
2. Check if there is any damage in the power cable.
3. Check if there is any damage in the Signal Booster’s connector.
Instructions to x ashing or solid red.