Owner manual

AMERICAN CAR CRAFT INSTRUCTIONS

POLISHED 2pc UPPER A/C VENT TRIM

PART#101010patent pending

PARTS INCLUDED:

2- A/C Trim Pieces

1-Adehesive Promoter

!!!!!VERY IMPORTANT!!!!!

BEFORE YOU BEGIN YOU MUST FIRST PREP YOUR DASH/DOOR AREAS WHERE PIECES

ARE GOING TO BE INSTALLED IN ORDER TO ALLOW ADHESION!!!!. You can do this by

scrubbing the entire area first with household isopropyl alcohol. NOTE: If these

areas have been treated with armor all or any such surface protector; installation

will NOT work unless these treatments have first been removed using special

chemicals. PLEASE REFER TO THE SPECIAL PREPARATION INSTRUCTION SHEET

ENCLOSED.

We can not be responsible for kits not sticking do to improper preparation!

PAGE 1
AMERICAN CAR CRAFT INSTRUCTIONS POLISHED 2pc UPPER A/C VENT TRIM PART#101010patent pending PARTS INCLUDED: 2- A/C Trim Pieces 1-Adehesive Promoter !!!!!VERY IMPORTANT!!!!! BEFORE YOU BEGIN YOU MUST FIRST PREP YOUR DASH/DOOR AREAS WHERE PIECES ARE GOING TO BE INSTALLED IN ORDER TO ALLOW ADHESION!!!!. You can do this by scrubbing the entire area first with household isopropyl alcohol.
PAGE 2
PLEASE NOTE: Installation errors are NOT manufacturing defects and parts can NOT be RETURNED due to improper installation. 1. Once your areas have been prepared use the adhesive promoter packs/tubes (provided) to wipe the areas of your dash/door that will be covered with your new stainless pieces. Allow a few seconds to dry. You have been provided with attachment tape test strips. Use one of these to test the tack. If it seams to stick well then you can proceed with your installation.