Owner manual

AMERICAN CAR CRAFT INSTRUCTIONS

CAMARO ZL1 BRUSHED STAINLESS DOOR KICK PLATES

PART # 101026 Patent Pending

PARTS INCLUDED:

2-Brushed Kick Plates

1-Test Kit

2-Adhesive Promoter Pack

YOUR DOOR GUARDS COME TO YOU WITH A PROTECTIVE LINER, DO NOT REMOVE

PROTECTIVE LINER UNTIL STEP 7. NOTE: FLAME GRAPHIC DOOR GUARDS DO NOT

HAVE A PROTECTIVE LINER.

!!!!!VERY IMPORTANT!!!!!

PAGE 1
AMERICAN CAR CRAFT INSTRUCTIONS CAMARO ZL1 BRUSHED STAINLESS DOOR KICK PLATES PART # 101026 Patent Pending PARTS INCLUDED: 2-Brushed Kick Plates 1-Test Kit 2-Adhesive Promoter Pack YOUR DOOR GUARDS COME TO YOU WITH A PROTECTIVE LINER, DO NOT REMOVE PROTECTIVE LINER UNTIL STEP 7. NOTE: FLAME GRAPHIC DOOR GUARDS DO NOT HAVE A PROTECTIVE LINER.
PAGE 2
PLEASE READ ALL INSTRUCTIONS BEFORE BEGINNING YOUR INSTALLATION! YOU MUST FOLLOW THESE INSTRUCTIONS EXACTLY OR YOUR NEW PANELS MAY NOT ADHERE. 1. BEFORE YOU BEGIN YOU MUST FIRST PREP THE DOOR PANEL IN ORDER TO ALLOW ADHESION!!!!. You can do this by scrubbing the entire area first with household isopropyl alcohol. Then closely follow the procedures outlined in the following steps!!!! 2.
PAGE 3
to the picture at the end of these instructions. Make note of its position. PLEASE NOTE: Metal will not bend out of place itself so if it is properly formed and installed the panels will remain in place. 5. Remove the red liner (be sure not to touch the adhesive) and carefully reposition the door guard, press firmly on the panel to set. 6. Remove protective liner. Then repeat steps 1-7 for the other door. Note: Care must be taken when cleaning your door guards.