User Manual

AMERICAN CAR CRAFT INSTRUCTIONS

300 WATER TANK COVER

PART#303019

PARTS INCLUDED:

1-Stainless Cover

1- Adhesive Promoter Pack

1-Replacement Pressure Cap

1-Chrome Decorative Cap Covers w/Velcro

1-1” Chrome Bolt Cover w/Butyl Putty

1-#14 7/8” Pan Head Screw

PAGE 1
AMERICAN CAR CRAFT INSTRUCTIONS 300 WATER TANK COVER PART#303019 PARTS INCLUDED: 1-Stainless Cover 1- Adhesive Promoter Pack 1-Replacement Pressure Cap 1-Chrome Decorative Cap Covers w/Velcro 1-1” Chrome Bolt Cover w/Butyl Putty 1-#14 7/8” Pan Head Screw
PAGE 2
This new cover has been designed to cover the factory water tank as well as the power steering reservoir and will provide a nice custom look to the area. The cover is simple to install with just a few steps. Your new cover comes to you with a protective liner. Do not remove this liner until prompted by instructions. 1. Remove the water tank pressure cap as well as the power steering cap. Remove the factory bolt just above and to the right side of the tank. NOTE: This factory bolt will not be reused. 2.